Difference between revisions of "Tektronix TekXPress XP338"

From LinuxMIPS
Jump to: navigation, search
Line 34: Line 34:
=== Links ===
=== Links ===
* Page on AtomicDOC Wiki: [http://atomicdoc.hopto.org/index.php/ULOS/Hardware/RISC/MIPS/Tektronix]
* Page on AtomicDOC Wiki: http://atomicdoc.hopto.org/index.php/ULOS/Hardware/RISC/MIPS/Tektronix

Revision as of 02:16, 16 January 2005

Tektronix TekXPress XP338

Note: Many of the eratta docs for the listed chips are in PDF format.

System Specifications

The "ERGO" Port

This port combines the keyboard, mouse and monitor into one single port. The "ERGO Cable" that plugs into this port, provides 3 BNC connectors for the video (this box uses Sync-on-Green like [SGI|ULOS/Hardware/RISC/MIPS/SGI] boxes do), and two PS2 sockets for the keyboard and mouse.

Parts Required:

  • 2x PS/2 Sockets: You may be able to purchase these -- I grabbed a dead ATX motherboard and took to it with a hacksaw.
  • 1x DB15 female plug.
  • 1x VGA 15pin female plug.
  • About 30cm of cable (I used some headphone wire for the video signal wires, and a bit of CAT5e for the keyboard & mouse)

The wiring looks like this:

File:Http://www.longlandclan.hopto.org/~stuartl/images/tektronix xp338/ergo cable.png


  • If you hacked the PS/2 sockets off a motherboard like I did, you might find that the sockets share common Ground and +5V rails. (that is, a tracks connect pin 5 and pin 2 of both sockets together) This is okay.
  • If you'd prefer to use BNC connections, then do so. It should be possible to substitute a BNC socket for each pair of connections on the VGA plug.