|To:||Peter Popov <firstname.lastname@example.org>, David Brownell <email@example.com>|
|Subject:||Re: [PATCH] Philips PNX8550 USB Host driver compile fix|
|From:||"Vladimir A. Barinov" <firstname.lastname@example.org>|
|Date:||Thu, 08 Dec 2005 19:51:50 +0300|
|Cc:||email@example.com, firstname.lastname@example.org, email@example.com|
|User-agent:||Mozilla Thunderbird 1.0.2-6 (X11/20050513)|
Hello Ralf, David, Could you please advise.What is the right solution in the situation when USB PCI and on-chip USB used in the situation when we want ohci-hcd to be a module?
Vladimir Peter Popov wrote:
I suppose the right solution is to be able to use the on-chip usb controller as well as an external pci controller. I don't think anyone will do that though. I have one board with an external USB controller but that was done in order to add usb 2.0 support, so the on-chip usb controller is not used. So the simple fix below works fine for me, but Ralf and David B. may have higher standards ;) Pete --- "Vladimir A. Barinov" <firstname.lastname@example.org> wrote:Hello, Ralf, Pete, The current ohci-hcd driver is a little defective. It's unable to use usb-ohci as modules in the casewhen PCI and on-chip USB are enabled.It just will not be compiled since there are twocalls if module_init in ohci-hcd.Please look at the patch attached. I 'm not sure is this patch well for this situation. Any suggestions are very appreciated. TIA, Vladimir--- linux-2.6.10.orig/drivers/usb/host/ohci-hcd.c2005-12-02 16:37:59.000000000 +0300 +++ linux-2.6.10/drivers/usb/host/ohci-hcd.c 2005-12-02 19:34:21.000000000 +0300 @@ -906,8 +906,12 @@ MODULE_LICENSE ("GPL"); #endif #ifdef CONFIG_PNX8550 +#if defined(CONFIG_PCI) && defined(CONFIG_USB_OHCI_HCD_MODULE) +#error "unable to compile PNX8550 USB and PCI USB as modules simultaneously until usb hcd stack is rewritten" +#else #include "ohci-pnx8550.c" #endif +#endif #ifdef CONFIG_USB_OHCI_HCD_PPC_SOC #include "ohci-ppc-soc.c" @@ -919,6 +923,7 @@ MODULE_LICENSE ("GPL"); || defined (CONFIG_ARCH_LH7A404) \ || defined (CONFIG_PXA27x) \ || defined (CONFIG_SOC_AU1X00) \ + || defined (CONFIG_PNX8550) \ || defined (CONFIG_USB_OHCI_HCD_PPC_SOC) \ ) #error "missing bus glue for ohci-hcd"
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||can read/write to mprotect(PROT_NONE) region with 2.6.14 on au1550, Clem Taylor|
|Next by Date:||Re: [PATCH] Philips PNX8550 command line patch, Vladimir A. Barinov|
|Previous by Thread:||Re: [PATCH] Philips PNX8550 USB Host driver compile fix, Peter Popov|
|Next by Thread:||Re: [PATCH] Philips PNX8550 USB Host driver compile fix, David Brownell|
|Indexes:||[Date] [Thread] [Top] [All Lists]|