The IOC3 implements the following functionality:
- 10/100Mbit/s ethernet interface. An external PHY is required and connected via a standard MII interface.
- a 486-style secondary bus. It's usually used to connect a SuperIO chip which contains a 16550 dual port UART.
- a controller for Dallas Semiconductor (now Maxim) 1-wire bus. In IP27 systems and on the PCI card a NIC containing the MAC address is connected to it. IP30 has several 1-wire devices connected.
- A PS/2-style mouse and keyboard interface.
The implementation of the IOC3 PCI configuration space violates the PCI specification severly by only partially decoding the configuration address space. Only Type 0 config cycles are supported. Only 32-bit accesses to the PCI interface are permitted. These limitations mean the IOC3 code needs special support in the PCI hostbridge driver.
The MENET card is an XIO card used in Origin and Octane systems. Interfacing to the host system via XIO it contains 4 IOC3 chips; 3 of them have serial interfaces connected accessible via 6 mini-DIN serial connectors.
The IOC3 PCI card is a short PCI card. Featuring PCI Dual Address Cycle support it can access the entire 64-bit address space. The IOC3 chip derives internal clocks from the PCI bus clock. It therefore will only work properly in 33MHz PCI busses. The PCI card also has mini-DIN connectors for PS/2 keyboard and mouse. This card is known in the Octanes as the chief part of the "CAD Duo" solution under the part number 030-1155-002.