linux-mips
[Top] [All Lists]

[PATCH 2/4] MIPS: lantiq: adds minimal dcdc driver

To: Ralf Baechle <ralf@linux-mips.org>
Subject: [PATCH 2/4] MIPS: lantiq: adds minimal dcdc driver
From: John Crispin <blogic@openwrt.org>
Date: Thu, 8 Aug 2013 11:07:24 +0200
Cc: linux-mips@linux-mips.org, John Crispin <blogic@openwrt.org>
In-reply-to: <1375952846-25812-1-git-send-email-blogic@openwrt.org>
List-archive: <http://www.linux-mips.org/archives/linux-mips/>
List-help: <mailto:ecartis@linux-mips.org?Subject=help>
List-id: linux-mips <linux-mips.eddie.linux-mips.org>
List-owner: <mailto:ralf@linux-mips.org>
List-post: <mailto:linux-mips@linux-mips.org>
List-software: Ecartis version 1.0.0
List-subscribe: <mailto:ecartis@linux-mips.org?subject=subscribe%20linux-mips>
List-unsubscribe: <mailto:ecartis@linux-mips.org?subject=unsubscribe%20linux-mips>
Original-recipient: rfc822;linux-mips@linux-mips.org
References: <1375952846-25812-1-git-send-email-blogic@openwrt.org>
Sender: linux-mips-bounce@linux-mips.org
This driver so far only reads the core voltage.

Signed-off-by: John Crispin <blogic@openwrt.org>
---
 arch/mips/lantiq/xway/Makefile |    2 +-
 arch/mips/lantiq/xway/dcdc.c   |   75 ++++++++++++++++++++++++++++++++++++++++
 2 files changed, 76 insertions(+), 1 deletion(-)
 create mode 100644 arch/mips/lantiq/xway/dcdc.c

diff --git a/arch/mips/lantiq/xway/Makefile b/arch/mips/lantiq/xway/Makefile
index 7a13660..087497d 100644
--- a/arch/mips/lantiq/xway/Makefile
+++ b/arch/mips/lantiq/xway/Makefile
@@ -1,3 +1,3 @@
-obj-y := prom.o sysctrl.o clk.o reset.o dma.o gptu.o
+obj-y := prom.o sysctrl.o clk.o reset.o dma.o gptu.o dcdc.o
 
 obj-$(CONFIG_XRX200_PHY_FW) += xrx200_phy_fw.o
diff --git a/arch/mips/lantiq/xway/dcdc.c b/arch/mips/lantiq/xway/dcdc.c
new file mode 100644
index 0000000..6361c30
--- /dev/null
+++ b/arch/mips/lantiq/xway/dcdc.c
@@ -0,0 +1,75 @@
+/*
+ *  This program is free software; you can redistribute it and/or modify it
+ *  under the terms of the GNU General Public License version 2 as published
+ *  by the Free Software Foundation.
+ *
+ *  Copyright (C) 2012 John Crispin <blogic@openwrt.org>
+ *  Copyright (C) 2010 Sameer Ahmad, Lantiq GmbH
+ */
+
+#include <linux/interrupt.h>
+#include <linux/ioport.h>
+#include <linux/module.h>
+#include <linux/of_platform.h>
+#include <linux/of_irq.h>
+
+#include <lantiq_soc.h>
+
+/* Bias and regulator Setup Register */
+#define DCDC_BIAS_VREG0        0xa
+/* Bias and regulator Setup Register */
+#define DCDC_BIAS_VREG1        0xb
+
+#define dcdc_w8(x, y)  ltq_w8((x), dcdc_membase + (y))
+#define dcdc_r8(x)     ltq_r8(dcdc_membase + (x))
+
+static void __iomem *dcdc_membase;
+
+static int dcdc_probe(struct platform_device *pdev)
+{
+       struct resource *res;
+
+       res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+       if (!res) {
+               dev_err(&pdev->dev, "Failed to get resource\n");
+               return -ENOMEM;
+       }
+
+       /* remap dcdc register range */
+       dcdc_membase = devm_request_and_ioremap(&pdev->dev, res);
+       if (!dcdc_membase) {
+               dev_err(&pdev->dev, "Failed to remap resource\n");
+               return -ENOMEM;
+       }
+
+       dev_info(&pdev->dev, "Core Voltage : %d mV\n",
+               dcdc_r8(DCDC_BIAS_VREG1) * 8);
+
+       return 0;
+}
+
+static const struct of_device_id dcdc_match[] = {
+       { .compatible = "lantiq,dcdc-xrx200" },
+       {},
+};
+MODULE_DEVICE_TABLE(of, dcdc_match);
+
+static struct platform_driver dcdc_driver = {
+       .probe = dcdc_probe,
+       .driver = {
+               .name = "dcdc-xrx200",
+               .owner = THIS_MODULE,
+               .of_match_table = dcdc_match,
+       },
+};
+
+int __init dcdc_init(void)
+{
+       int ret = platform_driver_register(&dcdc_driver);
+
+       if (ret)
+               pr_info("dcdc: Error registering platform driver\n");
+       return ret;
+}
+
+arch_initcall(dcdc_init);
-- 
1.7.10.4


<Prev in Thread] Current Thread [Next in Thread>