linux-mips
[Top] [All Lists]

[PATCH v99,08/13] MIPS: microMIPS: Add configuration option for microMIP

To: linux-mips@linux-mips.org
Subject: [PATCH v99,08/13] MIPS: microMIPS: Add configuration option for microMIPS kernel.
From: "Steven J. Hill" <sjhill@mips.com>
Date: Thu, 6 Dec 2012 23:05:32 -0600
Cc: "Steven J. Hill" <sjhill@mips.com>, ralf@linux-mips.org
In-reply-to: <1354856737-28678-1-git-send-email-sjhill@mips.com>
List-archive: <http://www.linux-mips.org/archives/linux-mips/>
List-help: <mailto:ecartis@linux-mips.org?Subject=help>
List-id: linux-mips <linux-mips.eddie.linux-mips.org>
List-owner: <mailto:ralf@linux-mips.org>
List-post: <mailto:linux-mips@linux-mips.org>
List-software: Ecartis version 1.0.0
List-subscribe: <mailto:ecartis@linux-mips.org?subject=subscribe%20linux-mips>
List-unsubscribe: <mailto:ecartis@linux-mips.org?subject=unsubscribe%20linux-mips>
References: <1354856737-28678-1-git-send-email-sjhill@mips.com>
Sender: linux-mips-bounce@linux-mips.org
From: "Steven J. Hill" <sjhill@mips.com>

This adds the option to build the Linux kernel using only the
microMIPS ISA. The resulting kernel binary is, at a minimum,
20% smaller than using the MIPS32R2 ISA.

Signed-off-by: Steven J. Hill <sjhill@mips.com>
---
 arch/mips/Kconfig                      |   11 +++
 arch/mips/Makefile                     |    1 +
 arch/mips/configs/sead3micro_defconfig |  125 ++++++++++++++++++++++++++++++++
 arch/mips/kernel/proc.c                |    4 +
 4 files changed, 141 insertions(+)
 create mode 100644 arch/mips/configs/sead3micro_defconfig

diff --git a/arch/mips/Kconfig b/arch/mips/Kconfig
index 99c3ad7..07f2dff 100644
--- a/arch/mips/Kconfig
+++ b/arch/mips/Kconfig
@@ -350,6 +350,7 @@ config MIPS_SEAD3
        select SYS_SUPPORTS_BIG_ENDIAN
        select SYS_SUPPORTS_LITTLE_ENDIAN
        select SYS_SUPPORTS_SMARTMIPS
+       select SYS_SUPPORTS_MICROMIPS
        select USB_ARCH_HAS_EHCI
        select USB_EHCI_BIG_ENDIAN_DESC
        select USB_EHCI_BIG_ENDIAN_MMIO
@@ -2087,6 +2088,13 @@ config CPU_HAS_SMARTMIPS
          you don't know you probably don't have SmartMIPS and should say N
          here.
 
+config CPU_MICROMIPS
+       depends on SYS_SUPPORTS_MICROMIPS
+       bool "Build kernel using microMIPS ISA"
+       help
+         When this option is enabled the kernel will be built using the
+         microMIPS ISA
+
 config CPU_HAS_WB
        bool
 
@@ -2149,6 +2157,9 @@ config SYS_SUPPORTS_HIGHMEM
 config SYS_SUPPORTS_SMARTMIPS
        bool
 
+config SYS_SUPPORTS_MICROMIPS
+       bool
+
 config ARCH_FLATMEM_ENABLE
        def_bool y
        depends on !NUMA && !CPU_LOONGSON2
diff --git a/arch/mips/Makefile b/arch/mips/Makefile
index 654b1ad..6f829de6 100644
--- a/arch/mips/Makefile
+++ b/arch/mips/Makefile
@@ -114,6 +114,7 @@ cflags-$(CONFIG_CPU_BIG_ENDIAN)             += $(shell 
$(CC) -dumpmachine |grep -q 'mips.*e
 cflags-$(CONFIG_CPU_LITTLE_ENDIAN)     += $(shell $(CC) -dumpmachine |grep -q 
'mips.*el-.*' || echo -EL $(undef-all) $(predef-le))
 
 cflags-$(CONFIG_CPU_HAS_SMARTMIPS)     += $(call cc-option,-msmartmips)
+cflags-$(CONFIG_CPU_MICROMIPS) += $(call cc-option,-mmicromips -mno-jals)
 
 cflags-$(CONFIG_SB1XXX_CORELIS)        += $(call cc-option,-mno-sched-prolog) \
                                   -fno-omit-frame-pointer
diff --git a/arch/mips/configs/sead3micro_defconfig 
b/arch/mips/configs/sead3micro_defconfig
new file mode 100644
index 0000000..403332f
--- /dev/null
+++ b/arch/mips/configs/sead3micro_defconfig
@@ -0,0 +1,125 @@
+CONFIG_MIPS_SEAD3=y
+CONFIG_CPU_LITTLE_ENDIAN=y
+CONFIG_CPU_MIPS32_R2=y
+CONFIG_CPU_MICROMIPS=y
+CONFIG_HZ_100=y
+CONFIG_EXPERIMENTAL=y
+CONFIG_SYSVIPC=y
+CONFIG_POSIX_MQUEUE=y
+CONFIG_NO_HZ=y
+CONFIG_HIGH_RES_TIMERS=y
+CONFIG_IKCONFIG=y
+CONFIG_IKCONFIG_PROC=y
+CONFIG_LOG_BUF_SHIFT=15
+CONFIG_EMBEDDED=y
+CONFIG_SLAB=y
+CONFIG_PROFILING=y
+CONFIG_OPROFILE=y
+CONFIG_MODULES=y
+# CONFIG_BLK_DEV_BSG is not set
+# CONFIG_CORE_DUMP_DEFAULT_ELF_HEADERS is not set
+CONFIG_NET=y
+CONFIG_PACKET=y
+CONFIG_UNIX=y
+CONFIG_INET=y
+CONFIG_IP_PNP=y
+CONFIG_IP_PNP_DHCP=y
+CONFIG_IP_PNP_BOOTP=y
+# CONFIG_INET_XFRM_MODE_TRANSPORT is not set
+# CONFIG_INET_XFRM_MODE_TUNNEL is not set
+# CONFIG_INET_XFRM_MODE_BEET is not set
+# CONFIG_INET_LRO is not set
+# CONFIG_INET_DIAG is not set
+# CONFIG_IPV6 is not set
+# CONFIG_WIRELESS is not set
+CONFIG_UEVENT_HELPER_PATH="/sbin/hotplug"
+CONFIG_MTD=y
+CONFIG_MTD_CHAR=y
+CONFIG_MTD_BLOCK=y
+CONFIG_MTD_CFI=y
+CONFIG_MTD_CFI_INTELEXT=y
+CONFIG_MTD_PHYSMAP=y
+CONFIG_MTD_UBI=y
+CONFIG_MTD_UBI_GLUEBI=y
+CONFIG_BLK_DEV_LOOP=y
+CONFIG_BLK_DEV_CRYPTOLOOP=m
+CONFIG_SCSI=y
+# CONFIG_SCSI_PROC_FS is not set
+CONFIG_BLK_DEV_SD=y
+CONFIG_CHR_DEV_SG=y
+# CONFIG_SCSI_LOWLEVEL is not set
+CONFIG_NETDEVICES=y
+CONFIG_SMSC911X=y
+# CONFIG_NET_VENDOR_WIZNET is not set
+CONFIG_MARVELL_PHY=y
+CONFIG_DAVICOM_PHY=y
+CONFIG_QSEMI_PHY=y
+CONFIG_LXT_PHY=y
+CONFIG_CICADA_PHY=y
+CONFIG_VITESSE_PHY=y
+CONFIG_SMSC_PHY=y
+CONFIG_BROADCOM_PHY=y
+CONFIG_ICPLUS_PHY=y
+# CONFIG_WLAN is not set
+# CONFIG_INPUT_MOUSEDEV is not set
+# CONFIG_INPUT_KEYBOARD is not set
+# CONFIG_INPUT_MOUSE is not set
+# CONFIG_SERIO is not set
+# CONFIG_CONSOLE_TRANSLATIONS is not set
+CONFIG_VT_HW_CONSOLE_BINDING=y
+CONFIG_LEGACY_PTY_COUNT=32
+CONFIG_SERIAL_8250=y
+CONFIG_SERIAL_8250_CONSOLE=y
+CONFIG_SERIAL_8250_NR_UARTS=2
+CONFIG_SERIAL_8250_RUNTIME_UARTS=2
+# CONFIG_HW_RANDOM is not set
+CONFIG_I2C=y
+# CONFIG_I2C_COMPAT is not set
+CONFIG_I2C_CHARDEV=y
+# CONFIG_I2C_HELPER_AUTO is not set
+CONFIG_SPI=y
+CONFIG_SENSORS_ADT7475=y
+CONFIG_BACKLIGHT_LCD_SUPPORT=y
+CONFIG_LCD_CLASS_DEVICE=y
+CONFIG_BACKLIGHT_CLASS_DEVICE=y
+# CONFIG_VGA_CONSOLE is not set
+CONFIG_USB=y
+CONFIG_USB_ANNOUNCE_NEW_DEVICES=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_EHCI_ROOT_HUB_TT=y
+CONFIG_USB_STORAGE=y
+CONFIG_MMC=y
+CONFIG_MMC_DEBUG=y
+CONFIG_MMC_SPI=y
+CONFIG_NEW_LEDS=y
+CONFIG_LEDS_CLASS=y
+CONFIG_LEDS_TRIGGERS=y
+CONFIG_LEDS_TRIGGER_HEARTBEAT=y
+CONFIG_RTC_CLASS=y
+CONFIG_RTC_DRV_M41T80=y
+CONFIG_EXT3_FS=y
+# CONFIG_EXT3_DEFAULTS_TO_ORDERED is not set
+CONFIG_XFS_FS=y
+CONFIG_XFS_QUOTA=y
+CONFIG_XFS_POSIX_ACL=y
+CONFIG_QUOTA=y
+# CONFIG_PRINT_QUOTA_WARNING is not set
+CONFIG_MSDOS_FS=m
+CONFIG_VFAT_FS=m
+CONFIG_TMPFS=y
+CONFIG_JFFS2_FS=y
+CONFIG_NFS_FS=y
+CONFIG_ROOT_NFS=y
+CONFIG_NLS_CODEPAGE_437=y
+CONFIG_NLS_ASCII=y
+CONFIG_NLS_ISO8859_1=y
+CONFIG_NLS_ISO8859_15=y
+CONFIG_NLS_UTF8=y
+# CONFIG_FTRACE is not set
+CONFIG_CRYPTO=y
+CONFIG_CRYPTO_CBC=y
+CONFIG_CRYPTO_ECB=y
+CONFIG_CRYPTO_AES=y
+CONFIG_CRYPTO_ARC4=y
+# CONFIG_CRYPTO_ANSI_CPRNG is not set
+# CONFIG_CRYPTO_HW is not set
diff --git a/arch/mips/kernel/proc.c b/arch/mips/kernel/proc.c
index 239ae03..54ac39a 100644
--- a/arch/mips/kernel/proc.c
+++ b/arch/mips/kernel/proc.c
@@ -76,6 +76,10 @@ static int show_cpuinfo(struct seq_file *m, void *v)
        if (cpu_has_mmips)      seq_printf(m, "%s", " micromips");
        seq_printf(m, "\n");
 
+       if (cpu_has_mmips) {
+               seq_printf(m, "micromips kernel\t: %s\n",
+                     (read_c0_config3() & MIPS_CONF3_ISA_OE) ?  "yes" : "no");
+       }
        seq_printf(m, "shadow register sets\t: %d\n",
                      cpu_data[n].srsets);
        seq_printf(m, "kscratch registers\t: %d\n",
-- 
1.7.9.5


<Prev in Thread] Current Thread [Next in Thread>