linux-mips
[Top] [All Lists]

[PATCH 17/18] MIPS: Alchemy: hook up IrDA on DB1000/DB1100

To: Linux-MIPS <linux-mips@linux-mips.org>, Ralf Baechle <ralf@linux-mips.org>
Subject: [PATCH 17/18] MIPS: Alchemy: hook up IrDA on DB1000/DB1100
From: Manuel Lauss <manuel.lauss@googlemail.com>
Date: Tue, 1 Nov 2011 20:03:43 +0100
Cc: Manuel Lauss <manuel.lauss@googlemail.com>
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=googlemail.com; s=gamma; h=from:to:cc:subject:date:message-id:x-mailer:in-reply-to:references; bh=hFpafFFOqe8LjOzUO+dZKr6NPHUcuu8yBex0xL/OlZQ=; b=HUgxWAfnhFxV7yAao+VQ4hu3BL1qlURWluWz60yIRMWW/DWrSJJKDcM3BEWR3MCyxS Lvv4IFhQdqu90HMjHIEFGL4VGear1vM9ECZRfwy7uUd0Y4dSPUNQPoeB5JbdFBsQUJ0q CLDmnZha486Rr08F//pH0gB7A9qpmtDbDjDto=
In-reply-to: <1320174224-27305-1-git-send-email-manuel.lauss@googlemail.com>
References: <1320174224-27305-1-git-send-email-manuel.lauss@googlemail.com>
Sender: linux-mips-bounce@linux-mips.org
Add necessary transceiver control platform data and hook up the
IrDA peripheral on the DB1000 and DB1100 boards.

Signed-off-by: Manuel Lauss <manuel.lauss@googlemail.com>
---
 arch/mips/alchemy/devboards/db1000.c |   74 ++++++++++++++++++++++++++--------
 1 files changed, 57 insertions(+), 17 deletions(-)

diff --git a/arch/mips/alchemy/devboards/db1000.c 
b/arch/mips/alchemy/devboards/db1000.c
index e531bfa..f62b180 100644
--- a/arch/mips/alchemy/devboards/db1000.c
+++ b/arch/mips/alchemy/devboards/db1000.c
@@ -65,23 +65,6 @@ void __init board_setup(void)
                  DB1000_BCSR_PHYS_ADDR + DB1000_BCSR_HEXLED_OFS);
 
        printk(KERN_INFO "AMD Alchemy %s Board\n", board_type_str());
-
-#if defined(CONFIG_IRDA) && defined(CONFIG_AU1000_FIR)
-       {
-               u32 pin_func;
-
-               /* Set IRFIRSEL instead of GPIO15 */
-               pin_func = au_readl(SYS_PINFUNC) | SYS_PF_IRF;
-               au_writel(pin_func, SYS_PINFUNC);
-               /* Power off until the driver is in use */
-               bcsr_mod(BCSR_RESETS, BCSR_RESETS_IRDA_MODE_MASK,
-                        BCSR_RESETS_IRDA_MODE_OFF);
-       }
-#endif
-       bcsr_write(BCSR_PCMCIA, 0);     /* turn off PCMCIA power */
-
-       /* Enable GPIO[31:0] inputs */
-       alchemy_gpio1_input_enable();
 }
 
 
@@ -388,6 +371,57 @@ static struct platform_device db1100_mmc1_dev = {
        .resource       = au1100_mmc1_res,
 };
 
+/******************************************************************************/
+
+static void db1000_irda_set_phy_mode(int mode)
+{
+       unsigned short mask = BCSR_RESETS_IRDA_MODE_MASK | BCSR_RESETS_FIR_SEL;
+
+       switch (mode) {
+       case AU1000_IRDA_PHY_MODE_OFF:
+               bcsr_mod(BCSR_RESETS, mask, BCSR_RESETS_IRDA_MODE_OFF);
+               break;
+       case AU1000_IRDA_PHY_MODE_SIR:
+               bcsr_mod(BCSR_RESETS, mask, BCSR_RESETS_IRDA_MODE_FULL);
+               break;
+       case AU1000_IRDA_PHY_MODE_FIR:
+               bcsr_mod(BCSR_RESETS, mask, BCSR_RESETS_IRDA_MODE_FULL |
+                                           BCSR_RESETS_FIR_SEL);
+               break;
+       }
+}
+
+static struct au1k_irda_platform_data db1000_irda_platdata = {
+       .set_phy_mode   = db1000_irda_set_phy_mode,
+};
+
+static struct resource au1000_irda_res[] = {
+       [0] = {
+               .start  = AU1000_IRDA_PHYS_ADDR,
+               .end    = AU1000_IRDA_PHYS_ADDR + 0x0fff,
+               .flags  = IORESOURCE_MEM,
+       },
+       [1] = {
+               .start  = AU1000_IRDA_TX_INT,
+               .end    = AU1000_IRDA_TX_INT,
+               .flags  = IORESOURCE_IRQ,
+       },
+       [2] = {
+               .start  = AU1000_IRDA_RX_INT,
+               .end    = AU1000_IRDA_RX_INT,
+               .flags  = IORESOURCE_IRQ,
+       },
+};
+
+static struct platform_device db1000_irda_dev = {
+       .name   = "au1000-irda",
+       .id     = -1,
+       .dev    = {
+               .platform_data = &db1000_irda_platdata,
+       },
+       .resource       = au1000_irda_res,
+       .num_resources  = ARRAY_SIZE(au1000_irda_res),
+};
 
 static struct platform_device *db1x00_devs[] = {
        &db1x00_codec_dev,
@@ -396,10 +430,15 @@ static struct platform_device *db1x00_devs[] = {
        &db1x00_audio_dev,
 };
 
+static struct platform_device *db1000_devs[] = {
+       &db1000_irda_dev,
+};
+
 static struct platform_device *db1100_devs[] = {
        &au1100_lcd_device,
        &db1100_mmc0_dev,
        &db1100_mmc1_dev,
+       &db1000_irda_dev,
 };
 
 static int __init db1000_dev_init(void)
@@ -433,6 +472,7 @@ static int __init db1000_dev_init(void)
                d1 = AU1000_GPIO3_INT;
                s0 = AU1000_GPIO1_INT;
                s1 = AU1000_GPIO4_INT;
+               platform_add_devices(db1000_devs, ARRAY_SIZE(db1000_devs));
        } else
                return 0; /* unknown board, no further dev setup to do */
 
-- 
1.7.7.1


<Prev in Thread] Current Thread [Next in Thread>