linux-mips
[Top] [All Lists]

Re: [PATCH] MTX-1: make au1000_eth probes all PHY addresses

To: Florian Fainelli <florian@openwrt.org>
Subject: Re: [PATCH] MTX-1: make au1000_eth probes all PHY addresses
From: Ralf Baechle <ralf@linux-mips.org>
Date: Fri, 4 Mar 2011 17:13:15 +0100
Cc: linux-mips@linux-mips.org
In-reply-to: <201102271953.54065.florian@openwrt.org>
Original-recipient: rfc822;linux-mips@linux-mips.org
References: <201102271953.54065.florian@openwrt.org>
Sender: linux-mips-bounce@linux-mips.org
User-agent: Mutt/1.5.21 (2010-09-15)
On Sun, Feb 27, 2011 at 07:53:53PM +0100, Florian Fainelli wrote:

> From: Florian Fainelli <florian@openwrt.org>
> 
> When au1000_eth probes the MII bus for PHY address, if we do not set 
> au1000_eth
> platform data's phy_search_highest_address, the MII probing logic will exit
> early and will assume a valid PHY is found at address 0. For MTX-1, the PHY is
> at address 31, and without this patch, the link detection/speed/duplex would 
> not
> work correctly.
> 
> CC: stable@kernel.org
> Signed-off-by: Florian Fainelli <florian@openwrt.org>
> ---
> Stable: 2.6.34+

Thanks, applied to 2.6.34+.  Note that while you added a
CC stable@kernel.org that address was not actually on the mail's cc list!

  Ralf

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [PATCH] MTX-1: make au1000_eth probes all PHY addresses, Ralf Baechle <=