On 02/23/2011 06:14 PM, David Gibson wrote:
On Wed, Feb 23, 2011 at 05:57:43PM -0800, David Daney wrote:
On 02/23/2011 03:49 PM, David Gibson wrote:
On Wed, Feb 23, 2011 at 11:06:30AM -0800, David Daney wrote:
On 02/22/2011 04:07 PM, David Gibson wrote:
On Tue, Feb 22, 2011 at 12:57:46PM -0800, David Daney wrote:
Signed-off-by: David Daney<firstname.lastname@example.org>
arch/mips/cavium-octeon/.gitignore | 2 +
arch/mips/cavium-octeon/Makefile | 13 ++
arch/mips/cavium-octeon/octeon_3xxx.dts | 314 +++++++++++++++++++++++++++++++
arch/mips/cavium-octeon/octeon_68xx.dts | 99 ++++++++++
4 files changed, 428 insertions(+), 0 deletions(-)
create mode 100644 arch/mips/cavium-octeon/.gitignore
create mode 100644 arch/mips/cavium-octeon/octeon_3xxx.dts
create mode 100644 arch/mips/cavium-octeon/octeon_68xx.dts
diff --git a/arch/mips/cavium-octeon/.gitignore
new file mode 100644
@@ -0,0 +1,2 @@
I think I have the correct .gitignore syntax.
What I meant was, where are you generating .dtb.S files that you need
to ignore them?
They are a byproduct of $(call cmd,dtc).
Normally make removes them automatically, but if you abort at just
the right time, they can be left around.
If it is objectionable, I can just remove that .gitignore bit.
No, if they're byproducts of cmd,dtc they should be there. I'm just a
bit baffled as to why cmd,dtc would produce such byproducts. dtc
itself will convert dts -> dtb without any extraneous intermediate
$(call cmd,dtc) does indeed just do the direct conversion. There are
other rules in scripts/Makefile.lib that convert the .dtb into a .dtb.o
file that generate the .dtb.S files.