Re: [PATCH 2/2] bcm63xx: only set the proper GPIO overlay settings

[Maxime Bizon <mbizon@freebox.fr>]

On Mon, 2009-08-31 at 20:28 +0200, Florian Fainelli wrote:

> This patch makes the GPIO pin multiplexing configuration
> read the initial GPIO mode register value instead of
> setting it initially to 0, then setting the correct
> bits, this is safer.

I disagree, now we get working or not working devices depending on the
CFE version used, for which we don't have any public source code nor
changelog.

I cleared the register for that purpose.

If a particular pin muxing config is needed for some board, we should
add this to the board specific struct instead.

-- 
Maxime