| To: | Atsushi Nemoto <anemo@mba.ocn.ne.jp> |
|---|---|
| Subject: | Re: [PATCH 1/2] ide: Add tx4939ide driver |
| From: | Sergei Shtylyov <sshtylyov@ru.mvista.com> |
| Date: | Thu, 11 Sep 2008 19:18:04 +0400 |
| Cc: | linux-mips@linux-mips.org, linux-ide@vger.kernel.org, bzolnier@gmail.com, ralf@linux-mips.org |
| In-reply-to: | <20080912.000349.18312151.anemo@mba.ocn.ne.jp> |
| Organization: | MontaVista Software Inc. |
| Original-recipient: | rfc822;linux-mips@linux-mips.org |
| References: | <48C6B768.4010200@ru.mvista.com> <20080911.003222.51867360.anemo@mba.ocn.ne.jp> <48C7EDE4.3090400@ru.mvista.com> <20080912.000349.18312151.anemo@mba.ocn.ne.jp> |
| Sender: | linux-mips-bounce@linux-mips.org |
| User-agent: | Mozilla/5.0 (X11; U; Linux i686; rv:1.7.2) Gecko/20040803 |
Atsushi Nemoto wrote: But the "Command Transfer Mode Select" bits affects access timings on setting task registers for DMA command. So what? PIO and DMA are different protocols on IDE bus, so they shouldn't affect each other. The IDE core will always tune the best PIO mode for you, so the optimal command timings will be set. Hmm, that would be a thing I had misunderstood. I thought set_pio_mode is not called when the drive was DMA capable. PIO autotuning was optional before (done only if the driver requested it via setting drive->autotune), but now done always. MBR, Sergei |
| Previous by Date: | Re: [Patch 2/6] MIPS: Add HARDWARE_WATCHPOINTS definitions and support code., David Daney |
|---|---|
| Next by Date: | [PATCH] rb532: provide GPIO_BUILTIN_NR and irq_to_gpio/gpio_to_irq, Florian Fainelli |
| Previous by Thread: | Re: [PATCH 1/2] ide: Add tx4939ide driver, Atsushi Nemoto |
| Next by Thread: | Re: [PATCH 1/2] ide: Add tx4939ide driver, Sergei Shtylyov |
| Indexes: | [Date] [Thread] [Top] [All Lists] |