Re: kexec on mips - anyone has it working?

[Tomasz Chmielewski <mangoo@wpkg.org>]

Nicolas Schichan schrieb:
> On Thursday 29 May 2008 22:15:47 Tomasz Chmielewski wrote:
> > # kexec -e
> > b44: eth0: powering down PHY
> > Starting new kernel
> > Will call new kernel at 00305000
> The calling address of the kernel looks quite wrong, it should clearly
> be inside the KSEG0 zone. could  you please indicate the output of the
> command "mips-linux-readelf -l vmlinux" ?
# uname -m
mips
# readelf -l vmlinux

Elf file type is EXEC (Executable file)
Entry point 0x80251b50
There are 2 program headers, starting at offset 52

Program Headers:
  Type           Offset   VirtAddr   PhysAddr   FileSiz MemSiz  Flg Align
  LOAD           0x001000 0x80001000 0x80001000 0x2dd07a 0x303250 RWE 
0x2000
  NOTE           0x000000 0x00000000 0x00000000 0x00000 0x00000 R   0x4

 Section to Segment mapping:
  Segment Sections...
   00     .text __ex_table __dbe_table .rodata .pci_fixup __ksymtab 
__ksymtab_gpl __ksymtab_strings __param .data .data.cacheline_aligned 
.init.text .init.data .init.setup .initcall.init .con_initcall.init 
.exit.text .init.ramfs .bss
   01

--
Tomasz Chmielewski
http://wpkg.org