linux-mips
[Top] [All Lists]

[PATCH] Pb1000: bury the remnants of the PCI code (part 2)

To: ralf@linux-mips.org
Subject: [PATCH] Pb1000: bury the remnants of the PCI code (part 2)
From: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Date: Tue, 29 Apr 2008 23:33:47 +0400
Cc: linux-mips@linux-mips.org
Organization: MontaVista Software Inc.
Original-recipient: rfc822;linux-mips@linux-mips.org
Sender: linux-mips-bounce@linux-mips.org
User-agent: KMail/1.5
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>

---
Here's the fragment I missed in the initial patch. Combine them if possible...

 arch/mips/au1000/pb1000/board_setup.c |    7 -------
 1 files changed, 7 deletions(-)

Index: linux-2.6/arch/mips/au1000/pb1000/board_setup.c
===================================================================
--- linux-2.6.orig/arch/mips/au1000/pb1000/board_setup.c
+++ linux-2.6/arch/mips/au1000/pb1000/board_setup.c
@@ -153,13 +153,6 @@ void __init board_setup(void)
        au_writel(0x280E3D07, MEM_STTIME3); /* 250ns cycle time */
        au_writel(0x10000000, MEM_STADDR3); /* any PCMCIA select */
 
-#ifdef CONFIG_PCI
-       au_writel(0, PCI_BRIDGE_CONFIG); // set extend byte to 0
-       au_writel(0, SDRAM_MBAR);        // set mbar to 0
-       au_writel(0x2, SDRAM_CMD);       // enable memory accesses
-       au_sync_delay(1);
-#endif
-
        /* Enable Au1000 BCLK switching - note: sed1356 must not use
         * its BCLK (Au1000 LCLK) for any timings */
        switch (prid & 0x000000FF)


<Prev in Thread] Current Thread [Next in Thread>
  • [PATCH] Pb1000: bury the remnants of the PCI code (part 2), Sergei Shtylyov <=