[PATCH 1/4] early_printk

[Frank Rowand <frank.rowand@am.sony.com>]

From: Frank Rowand <frank.rowand@am.sony.com>

Implement early printk in the serial_txx9 driver, and enable for the
Toshiba RBTX4927 board.  This is needed for the connect to GDB console
message.

Signed-off-by: Frank Rowand <frank.rowand@am.sony.com>
---
 arch/mips/Kconfig                                          |    1      1 +     
0 -     0 !
 arch/mips/tx4927/toshiba_rbtx4927/toshiba_rbtx4927_setup.c |    6      6 +     
0 -     0 !
 drivers/serial/serial_txx9.c                               |   39      39 +    
0 -     0 !
 3 files changed, 46 insertions(+)

Index: linux-2.6.24-rc7/arch/mips/Kconfig
===================================================================
--- linux-2.6.24-rc7.orig/arch/mips/Kconfig
+++ linux-2.6.24-rc7/arch/mips/Kconfig
@@ -631,6 +631,7 @@ config TOSHIBA_RBTX4927
        select I8259 if TOSHIBA_FPCIB0
        select SWAP_IO_SPACE
        select SYS_HAS_CPU_TX49XX
+       select SYS_HAS_EARLY_PRINTK
        select SYS_SUPPORTS_32BIT_KERNEL
        select SYS_SUPPORTS_64BIT_KERNEL
        select SYS_SUPPORTS_LITTLE_ENDIAN
Index: linux-2.6.24-rc7/drivers/serial/serial_txx9.c
===================================================================
--- linux-2.6.24-rc7.orig/drivers/serial/serial_txx9.c
+++ linux-2.6.24-rc7/drivers/serial/serial_txx9.c
@@ -1198,6 +1198,45 @@ MODULE_DEVICE_TABLE(pci, serial_txx9_pci
 
 static struct platform_device *serial_txx9_plat_devs;
 
+#ifdef CONFIG_EARLY_PRINTK
+
+/*
+ * Do NOT request the console resources, allows normal driver to initialize
+ * console later.
+ */
+
+static int prom_putchar_port = -1;
+
+void early_printk_serial_txx9_console_setup(void)
+{
+       prom_putchar_port = 0;
+}
+
+void prom_putchar(char ch)
+{
+       unsigned int status;
+       struct uart_txx9_port *up;
+
+       if (prom_putchar_port == -1)
+               return;
+
+       up = &serial_txx9_ports[prom_putchar_port];
+
+       if (ch == '\n')
+               prom_putchar('\r');
+
+       while (1) {
+               status = sio_in(up, TXX9_SICISR);
+               if (status & TXX9_SICISR_TRDY) {
+                       sio_out(up, TXX9_SITFIFO, (u32)ch);
+                       break;
+               }
+       }
+}
+
+#endif
+
+
 static int __init serial_txx9_init(void)
 {
        int ret;
Index: 
linux-2.6.24-rc7/arch/mips/tx4927/toshiba_rbtx4927/toshiba_rbtx4927_setup.c
===================================================================
--- 
linux-2.6.24-rc7.orig/arch/mips/tx4927/toshiba_rbtx4927/toshiba_rbtx4927_setup.c
+++ linux-2.6.24-rc7/arch/mips/tx4927/toshiba_rbtx4927/toshiba_rbtx4927_setup.c
@@ -913,6 +913,12 @@ void __init toshiba_rbtx4927_setup(void)
         if (strstr(argptr, "console=") == NULL) {
                 strcat(argptr, " console=ttyS0,38400");
         }
+#ifdef CONFIG_EARLY_PRINTK
+       {
+               extern void early_printk_serial_txx9_console_setup(void);
+               early_printk_serial_txx9_console_setup();
+       }
+#endif
 #endif
 #endif