Hi Ricardo,
On Tue, Dec 11, 2007 at 01:18:00PM -0400, Ricardo Mendoza wrote:
> Giuseppe Sacco wrote:
> > On Tue, Dec 11, 2007 at 09:26:42AM -0400, Ricardo Mendoza wrote:
> >> Giuseppe Sacco wrote:
> >>
> >>> I just checked that my repository is up to date, so my problem is still
> >>> there (thus I don't know if it is the same problem you fixed).
> >>>
> >>> BTW, what was the problem you fixed? I would like to have a look to it,
> >>> to better understand what's going on there.
> >> Well I just updated to see if anything had broken in the past few days,
> >> but I don't seem to be hitting that error of yours. Could you send your
> >> config to see if I can reproduce it?
> >
> > Yes, sure:
> > http://eppesuigoccas.homedns.org/~giuseppe/debian/config-2.6.24-rc4-ip32.bz2
> > but please note that the problem is present in every kernel since 2.6.24-rc1
> >
> > my boot stanza in arcboot is:
> >
> > label=test
> > image=/boot/vmlinux-2.6.24-rc4-gs1
> > append="root=/dev/sda1 ro video=gbefb:1024x768-16@60 debug initcall_debug
> > console=tty0 console=ttyS1,115200"
>
> Ran it without problems, can't get into much detail right now but I the
> problem you are seeing is more than likely caused by your other patch to
> serial_core.c.
I made a few run, recompiled everything from scratch, without my patch,
but I always had the system loop on IRQ #13 while booting.
Do you test on ip32? SGI O2 R5000@200? I would like to know any difference
between our test environments.
Thanks,
Gisueppe
|