linux-mips
[Top] [All Lists]

[PATCH] dz: Update Kconfig description

To: Andrew Morton <akpm@linux-foundation.org>
Subject: [PATCH] dz: Update Kconfig description
From: "Maciej W. Rozycki" <macro@linux-mips.org>
Date: Fri, 19 Oct 2007 21:34:41 +0100 (BST)
Cc: linux-mips@linux-mips.org, linux-serial@vger.kernel.org, linux-kernel@vger.kernel.org
Original-recipient: rfc822;linux-mips@linux-mips.org
Sender: linux-mips-bounce@linux-mips.org
 Reformat the Kconfig entries and update descriptions for accuracy.  
Select the driver by default for configurations of interest.  For the 
curious: 32BIT means only 32-bit DECstations support the device, not that 
the driver is not 64-bit clean; I have not checked that either though.

Signed-off-by: Maciej W. Rozycki <macro@linux-mips.org>
---
 Please apply,

  Maciej

patch-mips-2.6.18-20060920-dz-kconfig-2
diff -up --recursive --new-file 
linux-mips-2.6.18-20060920.macro/drivers/serial/Kconfig 
linux-mips-2.6.18-20060920/drivers/serial/Kconfig
--- linux-mips-2.6.18-20060920.macro/drivers/serial/Kconfig     2006-06-29 
05:03:07.000000000 +0000
+++ linux-mips-2.6.18-20060920/drivers/serial/Kconfig   2007-02-04 
20:18:36.000000000 +0000
@@ -385,20 +385,24 @@ config SERIAL_DZ
        bool "DECstation DZ serial driver"
        depends on MACH_DECSTATION && 32BIT
        select SERIAL_CORE
-       help
-         DZ11-family serial controllers for VAXstations, including the
-         DC7085, M7814, and M7819.
+       default y
+       ---help---
+         DZ11-family serial controllers for DECstations and VAXstations,
+         including the DC7085, M7814, and M7819.
 
 config SERIAL_DZ_CONSOLE
        bool "Support console on DECstation DZ serial driver"
        depends on SERIAL_DZ=y
        select SERIAL_CORE_CONSOLE
-       help
+       default y
+       ---help---
          If you say Y here, it will be possible to use a serial port as the
          system console (the system console is the device which receives all
          kernel messages and warnings and which allows logins in single user
-         mode).  Note that the firmware uses ttyS0 as the serial console on
-         the Maxine and ttyS2 on the others.
+         mode).
+
+         Note that the firmware uses ttyS3 as the serial console on
+         DECstations that use this driver.
 
          If unsure, say Y.
 

<Prev in Thread] Current Thread [Next in Thread>
  • [PATCH] dz: Update Kconfig description, Maciej W. Rozycki <=