[PATCH][au1x00/mtx1] - usb power switch

[John Crispin <john@phrozen.org>]

the gpio of the usb power switch for the mtx-1 is not pulled high due to 
wrong #ifdef
Signed-off-by: John Crispin <blogic@openwrt.org>
Signed-off-by: Felix Fietkau <nbd@openwrt.org>

--- linux-2.6.23.orig/arch/mips/au1000/mtx-1/board_setup.c      2007-07-29 
18:57:35.000000000 +0200
+++ linux-2.6.23/arch/mips/au1000/mtx-1/board_setup.c   2007-07-29 
18:59:48.000000000 +0200
@@ -54,7 +54,7 @@

void __init board_setup(void)
{
-#ifdef CONFIG_USB_OHCI
+#if defined(CONFIG_USB_OHCI_HCD) || defined(CONFIG_USB_OHCI_HCD_MODULE) 
	// enable USB power switch
        au_writel( au_readl(GPIO2_DIR) | 0x10, GPIO2_DIR );
        au_writel( 0x100001, GPIO2_OUTPUT );