Get rid of the cross-arch KGDB specific code which shouldn't have been there in
the first place...
Signed-off-by: Sergey Shtylyov <sshtylyov@ru.mvista.com>
---
arch/mips/emma2rh/markeins/setup.c | 24 ------------------------
1 files changed, 24 deletions(-)
Index: linux-mips/arch/mips/emma2rh/markeins/setup.c
===================================================================
--- linux-mips.orig/arch/mips/emma2rh/markeins/setup.c
+++ linux-mips/arch/mips/emma2rh/markeins/setup.c
@@ -115,30 +115,6 @@ extern void markeins_irq_setup(void);
static void inline __init markeins_sio_setup(void)
{
-#ifdef CONFIG_KGDB_8250
- struct uart_port emma_port;
-
- memset(&emma_port, 0, sizeof(emma_port));
-
- emma_port.flags =
- UPF_BOOT_AUTOCONF | UPF_SKIP_TEST;
- emma_port.iotype = UPIO_MEM;
- emma_port.regshift = 4; /* I/O addresses are every 8 bytes */
- emma_port.uartclk = 18544000; /* Clock rate of the chip */
-
- emma_port.line = 0;
- emma_port.mapbase = KSEG1ADDR(EMMA2RH_PFUR0_BASE + 3);
- emma_port.membase = (u8*)emma_port.mapbase;
- early_serial_setup(&emma_port);
-
- emma_port.line = 1;
- emma_port.mapbase = KSEG1ADDR(EMMA2RH_PFUR1_BASE + 3);
- emma_port.membase = (u8*)emma_port.mapbase;
- early_serial_setup(&emma_port);
-
- emma_port.irq = EMMA2RH_IRQ_PFUR1;
- kgdb8250_add_port(1, &emma_port);
-#endif
}
void __init plat_mem_setup(void)
|