linux-mips
[Top] [All Lists]

[PATCH][MIPS] fix Cobalt UART resource

To: Ralf Baechle <ralf@linux-mips.org>
Subject: [PATCH][MIPS] fix Cobalt UART resource
From: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Date: Thu, 18 Jan 2007 22:24:08 +0900
Cc: yoichi_yuasa@tripeaks.co.jp, linux-mips <linux-mips@linux-mips.org>
Organization: TriPeaks Corporation
Original-recipient: rfc822;linux-mips@linux-mips.org
Sender: linux-mips-bounce@linux-mips.org
Hi Ralf,

This patch has fixed UART I/O type.
The cobalt UART device is connected to memory resource.

Yoichi

Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>

diff -pruN -X mips/Documentation/dontdiff mips-orig/arch/mips/cobalt/setup.c 
mips/arch/mips/cobalt/setup.c
--- mips-orig/arch/mips/cobalt/setup.c  2006-12-09 19:03:28.738974000 +0900
+++ mips/arch/mips/cobalt/setup.c       2006-12-09 19:32:33.329616250 +0900
@@ -130,7 +130,7 @@ void __init plat_mem_setup(void)
 
        set_io_port_base(CKSEG1ADDR(GT_DEF_PCI0_IO_BASE));
 
-       /* I/O port resource must include UART and LCD/buttons */
+       /* I/O port resource must include LCD/buttons */
        ioport_resource.end = 0x0fffffff;
 
        /* request I/O space for devices used on all i[345]86 PCs */
@@ -149,24 +149,24 @@ void __init plat_mem_setup(void)
        register_pci_controller(&cobalt_pci_controller);
 #endif
 
-#ifdef CONFIG_SERIAL_8250
        if (cobalt_board_id > COBALT_BRD_ID_RAQ1) {
-
 #ifdef CONFIG_EARLY_PRINTK
                cobalt_early_console();
 #endif
 
+#ifdef CONFIG_SERIAL_8250
                uart.line       = 0;
                uart.type       = PORT_UNKNOWN;
                uart.uartclk    = 18432000;
                uart.irq        = COBALT_SERIAL_IRQ;
-               uart.flags      = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST;
-               uart.iobase     = 0xc800000;
-               uart.iotype     = UPIO_PORT;
+               uart.flags      = UPF_IOREMAP | UPF_BOOT_AUTOCONF |
+                                 UPF_SKIP_TEST;
+               uart.iotype     = UPIO_MEM;
+               uart.mapbase    = 0x1c800000;
 
                early_serial_setup(&uart);
-       }
 #endif
+       }
 }
 
 /*

<Prev in Thread] Current Thread [Next in Thread>
  • [PATCH][MIPS] fix Cobalt UART resource, Yoichi Yuasa <=