OSK ARM board automatic rebooting procedure...

["Naik, Sachidananda" <sachidananda.naik@ap.sony.com>]

Hi all,

 

I'm trying to achieve automatic restarting of ARM Board : OMAP 5012 OSK board. For that I found a link and I went through it.

 

Here is the link that discusses about Ebony board reboot procedure ::

           

http://tree.celinuxforum.org/CelfPubWiki/TargetSwitchControlFromParallelPort?action="">

In the link :

        1. They have taken DB25 connector ::

                            I'm not familiar with this device : Anybody who knows better about this device please send some information abt it.

        2. They have used the parport device driver :

                            Inside the source file, parport.c in the link , they are taking some addresses, I wan to kno abt those addresses.

        3. And In the module they have developed, the four pins are there to connect on the target board, In the OMAP 5012 OSK board where to connect these

            wires.

Please reply with some information.

Thanks and Regards

Sachidananda Naik

---

This email is confidential and intended only for the use of the individual or entity named above and may contain information that is privileged. If you are not the intended recipient, you are notified that any dissemination, distribution or copying of this email is strictly prohibited. If you have received this email in error, please notify us immediately by return email or telephone and destroy the original message. - This mail is sent via Sony Asia Pacific Mail Gateway.

---