Hi All,
i am using the sanblaze card
configured in the kernel for the fiberchannel. i enabled the mpt fusion fc and
the ioctl driver, i also enable scsi disk support, ...
I get an error and it hangs.
Has any one used the
sanblaze fc driver in the kernel (I am using kernel version 2.6.17.7)
Thx,
Bill Azer
i tried loading the drivers
and get this error :
bash-2.05b# insmod
drivers/message/fusion/mptbase.ko
Fusion MPT base driver
3.03.09
Copyright (c) 1999-2005 LSI
Logic Corporation
bash-2.05b# insmod
drivers/message/fusion/mptctl.ko
Fusion MPT misc device
(ioctl) driver 3.03.09
mptctl: Registered with
Fusion MPT base driver
mptctl: /dev/mptctl @
(major,minor=10,220)
bash-2.05b# insmod
drivers/message/fusion/mptscsih.ko
bash-2.05b# insmod
drivers/scsi/scsi_transport_fc.ko
bash-2.05b# insmod
/lib/modules/2.6.17.7/kernel/drivers/message/fusion/mptfc.ko
Fusion MPT FC Host driver
3.03.09
mptbase: Initiating ioc0
bringup
ioc0: FC929:
Capabilities={Initiator,Target,LAN}
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)!
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)!
mptbase: Initiating ioc0
recovery
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (130)!
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)!
mptbase: Initiating ioc0
recovery
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)!
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)!
mptbase: Initiating ioc0
recovery
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)!
scsi0 : ioc0: LSIFC929,
FwRev=02000a00h, Ports=1, MaxQ=1023, IRQ=10
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)!
mptbase: Initiating ioc0
recovery
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)!
mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)!