linux-mips
[Top] [All Lists]

[PATCH] removes unused functions for GT64120

To: Ralf Baechle <ralf@linux-mips.org>
Subject: [PATCH] removes unused functions for GT64120
From: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Date: Tue, 20 Jun 2006 21:33:02 +0900
Cc: linux-mips@linux-mips.org
Organization: TriPeaks Corporation
Original-recipient: rfc822;linux-mips@linux-mips.org
Sender: linux-mips-bounce@linux-mips.org
Hi Ralf,

This patch removes unused functions for GT64120.
Please apply.

Yoichi


Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>

diff -pruN -X mips/Documentation/dontdiff 
mips-orig/arch/mips/gt64120/common/Makefile 
mips/arch/mips/gt64120/common/Makefile
--- mips-orig/arch/mips/gt64120/common/Makefile 2006-06-20 14:14:56.915586750 
+0900
+++ mips/arch/mips/gt64120/common/Makefile      2006-06-20 15:15:01.158879000 
+0900
@@ -3,4 +3,3 @@
 #
 
 obj-y                  += time.o
-obj-$(CONFIG_PCI)      += pci.o
diff -pruN -X mips/Documentation/dontdiff 
mips-orig/arch/mips/gt64120/common/pci.c mips/arch/mips/gt64120/common/pci.c
--- mips-orig/arch/mips/gt64120/common/pci.c    2006-06-20 14:14:56.915586750 
+0900
+++ mips/arch/mips/gt64120/common/pci.c 1970-01-01 09:00:00.000000000 +0900
@@ -1,147 +0,0 @@
-/*
- * BRIEF MODULE DESCRIPTION
- * Galileo Evaluation Boards PCI support.
- *
- * The general-purpose functions to read/write and configure the GT64120A's
- * PCI registers (function names start with pci0 or pci1) are either direct
- * copies of functions written by Galileo Technology, or are modifications
- * of their functions to work with Linux 2.4 vs Linux 2.2.  These functions
- * are Copyright - Galileo Technology.
- *
- * Other functions are derived from other MIPS PCI implementations, or were
- * written by RidgeRun, Inc,  Copyright (C) 2000 RidgeRun, Inc.
- *   glonnon@ridgerun.com, skranz@ridgerun.com, stevej@ridgerun.com
- *
- *  This program is free software; you can redistribute  it and/or modify it
- *  under  the terms of  the GNU General  Public License as published by the
- *  Free Software Foundation;  either version 2 of the  License, or (at your
- *  option) any later version.
- *
- *  THIS  SOFTWARE  IS PROVIDED   ``AS  IS'' AND   ANY  EXPRESS OR IMPLIED
- *  WARRANTIES,   INCLUDING, BUT NOT  LIMITED  TO, THE IMPLIED WARRANTIES OF
- *  MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.  IN
- *  NO  EVENT  SHALL   THE AUTHOR  BE    LIABLE FOR ANY   DIRECT, INDIRECT,
- *  INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
- *  NOT LIMITED   TO, PROCUREMENT OF  SUBSTITUTE GOODS  OR SERVICES; LOSS OF
- *  USE, DATA,  OR PROFITS; OR  BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
- *  ANY THEORY OF LIABILITY, WHETHER IN  CONTRACT, STRICT LIABILITY, OR TORT
- *  (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
- *  THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
- *
- *  You should have received a copy of the  GNU General Public License along
- *  with this program; if not, write  to the Free Software Foundation, Inc.,
- *  675 Mass Ave, Cambridge, MA 02139, USA.
- */
-#include <linux/init.h>
-#include <linux/types.h>
-#include <linux/pci.h>
-#include <linux/kernel.h>
-#include <asm/gt64120.h>
-
-#define SELF 0
-
-/*
- * pciXReadConfigReg  - Read from a PCI configuration register
- *                    - Make sure the GT is configured as a master before
- *                      reading from another device on the PCI.
- *                   - The function takes care of Big/Little endian conversion.
- * INPUTS:   regOffset: The register offset as it apears in the GT spec (or PCI
- *                        spec)
- *           pciDevNum: The device number needs to be addressed.
- * RETURNS: data , if the data == 0xffffffff check the master abort bit in the
- *                 cause register to make sure the data is valid
- *
- *  Configuration Address 0xCF8:
- *
- *       31 30    24 23  16 15  11 10     8 7      2  0     <=bit Number
- *  |congif|Reserved|  Bus |Device|Function|Register|00|
- *  |Enable|        |Number|Number| Number | Number |  |    <=field Name
- *
- */
-static unsigned int pci0ReadConfigReg(int offset, struct pci_dev *device)
-{
-       unsigned int DataForRegCf8;
-       unsigned int data;
-
-       DataForRegCf8 = ((PCI_SLOT(device->devfn) << 11) |
-                        (PCI_FUNC(device->devfn) << 8) |
-                        (offset & ~0x3)) | 0x80000000;
-       GT_WRITE(GT_PCI0_CFGADDR_OFS, DataForRegCf8);
-
-       /*
-        * The casual observer might wonder why the READ is duplicated here,
-        * rather than immediately following the WRITE, and just have the swap
-        * in the "if".  That's because there is a latency problem with trying
-        * to read immediately after setting up the address register.  The "if"
-        * check gives enough time for the address to stabilize, so the READ
-        * can work.
-        */
-       if (PCI_SLOT(device->devfn) == SELF)    /* This board */
-               return GT_READ(GT_PCI0_CFGDATA_OFS);
-       else            /* PCI is little endian so swap the Data. */
-               return __GT_READ(GT_PCI0_CFGDATA_OFS);
-}
-
-/*
- * pciXWriteConfigReg - Write to a PCI configuration register
- *                    - Make sure the GT is configured as a master before
- *                      writingto another device on the PCI.
- *                    - The function takes care of Big/Little endian 
conversion.
- * Inputs:   unsigned int regOffset: The register offset as it apears in the
- *           GT spec
- *                   (or any other PCI device spec)
- *           pciDevNum: The device number needs to be addressed.
- *
- *  Configuration Address 0xCF8:
- *
- *       31 30    24 23  16 15  11 10     8 7      2  0     <=bit Number
- *  |congif|Reserved|  Bus |Device|Function|Register|00|
- *  |Enable|        |Number|Number| Number | Number |  |    <=field Name
- *
- */
-static void pci0WriteConfigReg(unsigned int offset,
-                              struct pci_dev *device, unsigned int data)
-{
-       unsigned int DataForRegCf8;
-
-       DataForRegCf8 = ((PCI_SLOT(device->devfn) << 11) |
-                        (PCI_FUNC(device->devfn) << 8) |
-                        (offset & ~0x3)) | 0x80000000;
-       GT_WRITE(GT_PCI0_CFGADDR_OFS, DataForRegCf8);
-
-       if (PCI_SLOT(device->devfn) == SELF)    /* This board */
-               GT_WRITE(GT_PCI0_CFGDATA_OFS, data);
-       else                    /* configuration Transaction over the pci. */
-               __GT_WRITE(GT_PCI0_CFGDATA_OFS, data);
-}
-
-extern struct pci_ops gt64120_pci_ops;
-
-void __init pcibios_init(void)
-{
-       u32 tmp;
-       struct pci_dev controller;
-
-       controller.devfn = SELF;
-
-       tmp = GT_READ(GT_PCI0_CMD_OFS);         /* Huh??? -- Ralf  */
-       tmp = GT_READ(GT_PCI0_BARE_OFS);
-
-       /*
-        * You have to enable bus mastering to configure any other
-        * card on the bus.
-        */
-       tmp = pci0ReadConfigReg(PCI_COMMAND, &controller);
-       tmp |= PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER | PCI_COMMAND_SERR;
-       pci0WriteConfigReg(PCI_COMMAND, &controller, tmp);
-
-       /*
-        *  Reset PCI I/O and PCI MEM values to ones supported by EVM.
-        */
-       ioport_resource.start   = GT_PCI_IO_BASE;
-       ioport_resource.end     = GT_PCI_IO_BASE + GT_PCI_IO_SIZE - 1;
-       iomem_resource.start    = GT_PCI_MEM_BASE;
-       iomem_resource.end      = GT_PCI_MEM_BASE + GT_PCI_MEM_SIZE - 1;
-
-       pci_scan_bus(0, &gt64120_pci_ops, NULL);
-}

<Prev in Thread] Current Thread [Next in Thread>
  • [PATCH] removes unused functions for GT64120, Yoichi Yuasa <=