linux-mips
[Top] [All Lists]

Re: compiling BCM5700 driver

To: "Ralf Baechle" <ralf@linux-mips.org>
Subject: Re: compiling BCM5700 driver
From: "Roman Mashak" <mrv@corecom.co.kr>
Date: Wed, 31 May 2006 10:54:31 +0900
Cc: <linux-mips@linux-mips.org>
Fl-build: Fidolook 2002 (SL) 6.0.2800.86 - 14/6/2003 22:16:25
Original-recipient: rfc822;linux-mips@linux-mips.org
References: <000101c6838e$437abdf0$9d0ba8c0@mrv> <20060530140616.GA18432@linux-mips.org>
Sender: linux-mips-bounce@linux-mips.org
Hello, Ralf!
You wrote to "Roman Mashak" <mrv@corecom.co.kr> on Tue, 30 May 2006 15:06:16 +0100:

??>> I try to compile BCM5700 driver of gigabit ethernet card for MIPS
??>> target. I used both toolchains (from PMC-sierra and self-made
??>> following http://www.kegel.com/crosstool recommendations). Get same
??>> errors: In file included from mm.h:151,                from
??>> b57um.c:19: tigon3.h:2225: unnamed fields of type other than struct or
??>> union are not allowed

RB> Broadcom's old and infamous Tigon 3 driver.  Dump it, use tg3, be
RB> happy.
I ran across problems with Trigon3 driver working in bridge mode. Upon replacement it with bcm5700 - all problems have gone.
Anyway, I managed to compile driver and now I'm testing it.

I'm more concerned with Titan GE driver on "Sequoia" board (by PMC-sierra). What's the status of this driver in 2.4.26? If I understand correct - it's maintained now only in 2.6.x? Upon compilation of 2.4.26 for Sequoia" board and installation on to target, we observed a lot of CRC errors on gigabit ethernet (we used SmartBit for testing). Is the driver in this version broken?

With best regards, Roman Mashak. E-mail: mrv@corecom.co.kr


<Prev in Thread] Current Thread [Next in Thread>