linux-mips
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

How can I use DBAu1550 UART3 instead of UART0?

from [Charles C.K.Lai] [Permanent Link][Original]
To: <linux-mips@linux-mips.org>
Subject: How can I use DBAu1550 UART3 instead of UART0?
From: "Charles C.K.Lai" <cklai@itri.org.tw>
Date: Wed, 3 May 2006 11:16:01 +0800
Original-recipient: rfc822;linux-mips@linux-mips.org
Reply-to: "Charles C.K.Lai" <cklai@itri.org.tw>
Sender: linux-mips-bounce@linux-mips.org 
Dear All, 

    I have a AMD DBAu1550 Development board, 
    if I have to use the uart port 3 instead of uart port 0, 
    what can I do? 

    Thanks a lot. 

    Charles C.K. Lai
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  changing IP address on mipsel-linux, Ratin
Next by Date:  Re: changing IP address on mipsel-linux, Freddy Spierenburg
Previous by Thread:  Re: SETNAME (set nodename) in syscall.c, Ralf Baechle
Next by Thread:  Re: How can I use DBAu1550 UART3 instead of UART0?, Freddy Spierenburg
Indexes:  [Date] [Thread] [Top] [All Lists]