Broadcom Bigsur build

["Michael J. Hammel" <mips@graphics-muse.org>]

Does anyone have a sample config file for use with 2.6.14.6 that boots a
BigSur board?  I've tried this kernel using the mips patch (via Cross
Linux From Scratch) but the boot locks up right after printing the board
type:

CFE> boot -elf 172.22.251.154:vmlinux-2.6.14.6
Loader:elf Filesys:tftp Dev:eth0 File:172.22.251.154:vmlinux-2.6.14.6
Options:()Loading: 0xffffffff80100000/3596456 0xffffffff8046e0a8/307112
Entry at 0x8043400Closing network.
Starting program at 0x80434000
[RUN!]
Broadcom SiByte BCM1480 S0 (pass1) @ 600 MHz (SB-1A rev 0)
Board type: SiByte BCM91x80A/B (BigSur)

-- 
Michael J. Hammel <mips@graphics-muse.org>