linux-mips
[Top] [All Lists]

Re: booting error on db1550 using linux 2.6.12 from linux-mips.org

To: ppopov@embeddedalley.com
Subject: Re: booting error on db1550 using linux 2.6.12 from linux-mips.org
From: rolf liu <rolfliu@gmail.com>
Date: Wed, 6 Jul 2005 15:15:57 -0700
Cc: "linux-mips@linux-mips.org" <linux-mips@linux-mips.org>
Domainkey-signature: a=rsa-sha1; q=dns; c=nofws; s=beta; d=gmail.com; h=received:message-id:date:from:reply-to:to:subject:cc:in-reply-to:mime-version:content-type:content-transfer-encoding:content-disposition:references; b=YFm55Dv0yQCFuH8P3uDtTGFCuiIjZI/9JHdGu4nYvtRQ1l9AbUQCtMqp1xo/V1zxZrlY6/5XisLkP17fNg+D9DUsgPjWY0N5hmnz1PwwwKRZbuvKP5up078FFH0L1/df+U7UZTBDlr3qFqHhWorHC8ASzefrp+n78kJhTCnnCBo=
In-reply-to: <1120633934.5724.29.camel@localhost.localdomain>
Original-recipient: rfc822;linux-mips@linux-mips.org
References: <2db32b7205070114172483d2dd@mail.gmail.com> <1120253048.5987.16.camel@localhost.localdomain> <2db32b72050701153566c83bb6@mail.gmail.com> <1120257851.5987.37.camel@localhost.localdomain> <2db32b7205070508504b675dd6@mail.gmail.com> <1120633934.5724.29.camel@localhost.localdomain>
Reply-to: rolf liu <rolfliu@gmail.com>
Sender: linux-mips-bounce@linux-mips.org
Pete,
could you give me some clues how I can make hpt371n work under linux 2.6? 
Is there a need to force the 371n to use 372n timing? 
can just timing issue cause the kernel to crash (panic)? 

Thanks


On 7/6/05, Pete Popov <ppopov@embeddedalley.com> wrote:
> On Tue, 2005-07-05 at 08:50 -0700, rolf liu wrote:
> > Pete,
> > I tried to make HPT working on db1550 for linux 2.6.12 cvs head. If I
> > didn't force it to use 372 timing, it just hangs up after it detect
> > the drive. If I used the 372 timing using the 2.4 trick, the kernel
> > just crashed. Any clue?
> 
> Other than the call trace you can see below, no, no clues. I would have
> to spend some time debugging it and if it ever becomes a priority, I
> will.
> 
> Pete
> 
> > Thanks
> >
> > Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
> > ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
> > HPT371: IDE controller at PCI slot 0000:00:0b.0
> > PCI: Enabling device 0000:00:0b.0 (0000 -> 0003)
> > HPT371: chipset revision 2
> > hpt: HPT372N detected, using 372N timing.
> > FREQ: 73 PLL: 35
> > HPT371: 100% native mode on irq 5
> > hpt: no known IDE timings, disabling DMA.
> > hpt: no known IDE timings, disabling DMA.
> > hdg: IBM-DTTA-350840, ATA DISK drive
> > CPU 0 Unable to handle kernel paging request at virtual address
> > 00000000, epc == 8029fb20, ra == 8029fc0c
> > Oops in arch/mips/mm/fault.c::do_page_fault, line 167[#1]:
> > Cpu 0
> > $ 0   : 00000000 1000fc00 00000000 00000000
> > $ 4   : 0000000c 00000000 00010000 18010017
> > $ 8   : 00000000 0000fc00 00000000 803a6000
> > $12   : 803ace64 fffffffb ffffffff 0000140d
> > $16   : 00000048 00000055 30070000 00000001
> > $20   : 804a1800 0000000c 8043a678 8043a5f8
> > $24   : 00000000 802a747c
> > $28   : 811de000 811dfe40 1000fc01 8029fc0c
> > Hi    : 0000018a
> > Lo    : 3d6edc00
> > epc   : 8029fb20 pci_bus_clock_list+0x0/0x38     Not tainted
> > ra    : 8029fc0c hpt372_tune_chipset+0xb4/0x138
> > Status: 1000fc03    KERNEL EXL IE
> > Cause : 00800008
> > BadVA : 00000000
> > PrId  : 03030200
> > Modules linked in:
> > Process swapper (pid: 1, threadinfo=811de000, task=80456bf0)
> > Stack : 804a1800 00000005 8029f62c 80456bf0 00000000 00000000 804a1800 
> > 0000000c
> >         8043a678 00000001 00000000 803b0000 00000005 8029fcf8 8043a678 
> > 8043a5e8
> >         00000000 00000001 00000000 803b0000 00000005 8043a5f8 8043a678 
> > 8043a5e8
> >         00000000 00000001 00000000 803b0000 00000005 802abd0c 00000005 
> > 8043a5f8
> >         b0400074 b040006c 00000001 811dff30 00000000 00000000 00000000 
> > 8043a5e8
> >         ...
> > Call Trace:
> >  [<8029f62c>] hpt_minimum_revision+0x2c/0xec
> >  [<8029fcf8>] hpt3xx_tune_chipset+0x68/0x2e8
> >  [<802abd0c>] probe_hwif+0x8a4/0x910
> >  [<802ace2c>] probe_hwif_init_with_fixup+0x1c/0xcc
> >  [<802af8bc>] ide_setup_pci_device+0xa8/0xcc
> >  [<8024f09c>] idr_get_new+0x18/0x4c
> >  [<80422e38>] ide_scan_pcidev+0x84/0xc4
> >  [<801c5464>] proc_register+0x48/0x16c
> >  [<80422eb0>] ide_scan_pcibus+0x38/0xf8
> >  [<801c5874>] proc_mkdir_mode+0x54/0x80
> >  [<80422d98>] ide_init+0x68/0x84
> >  [<80422d7c>] ide_init+0x4c/0x84
> >  [<801004f8>] init+0x9c/0x264
> >  [<80105e20>] kernel_thread_helper+0x10/0x18
> >  [<80105e10>] kernel_thread_helper+0x0/0x18
> >
> >
> > Code: 02002821  080a7e5f  a3a20013 <90a20000> 10400008  308400ff
> > 00401821  10640007  00000000
> > Kernel panic - not syncing: Attempted to kill init!
> >
> 
>

<Prev in Thread] Current Thread [Next in Thread>