On Tue, 24 May 2005 00:54:47 +0900 (JST)
Atsushi Nemoto <anemo@mba.ocn.ne.jp> wrote:
> >>>>> On Mon, 23 May 2005 18:45:01 +0400, Dmitriy Tochansky <toch@dfpost.ru>
> >>>>> said:
>
> toch> Im enable cardbus yenta type in kernel config and see the
> toch> follow:
>
> toch> yenta 0000:00:11.0: Preassigned resource 0 busy, reconfiguring...
> toch> yenta 0000:00:11.0: Preassigned resource 1 busy, reconfiguring...
>
> I think these messages are due to confliction with resource management
> codes in drivers/pci/setup-bus.c. Though I do not see details yet,
> this quick workaround might solve this issue.
>
> --- linux-mips/drivers/pcmcia/yenta_socket.c 2005-04-18 00:43:34.000000000
> +0900
> +++ linux/drivers/pcmcia/yenta_socket.c 2005-05-04 00:21:38.000000000
> +0900
> @@ -611,10 +611,12 @@
Well, yes, the resourse problem "dissapear", but irq is still asking to
report. I'll try to check setup-bus.c becourse IMHO there is problem in irq
assignment or something.
Yenta: CardBus bridge found at 0000:00:11.0 [e4bf:2000]
Yenta: Enabling burst memory read transactions
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:00:11.0, mfunc 0x0fc01d02, devctl 0x66
drivers/pcmcia/ti113x.h pci_irq_status = 0
Yenta TI: socket 0000:00:11.0 probing PCI interrupt failed, trying to fix
Yenta TI: socket 0000:00:11.0 falling back to parallel PCI interrupts
Yenta TI: socket 0000:00:11.0 no PCI interrupts. Fish. Please report.
CPU 0 Unable to handle kernel paging request at virtual address 00000004, epc =c
Oops in arch/mips/mm/fault.c::do_page_fault, line 167[#1]:
--
Dmitriy Tochansky
toch@dfpost.ru
JID: dtoch@jabber.ru
|