Hi!
Cant get where is the problem.
Look. I have pci->pcmcia cardbus adaptor CP3-HOUSE and I want to start it on
mips.
Im enable cardbus yenta type in kernel config and see the follow:
Yenta: CardBus bridge found at 0000:00:11.0 [e4bf:2000]
yenta 0000:00:11.0: Preassigned resource 0 busy, reconfiguring...
yenta 0000:00:11.0: Preassigned resource 1 busy, reconfiguring...
Yenta: Enabling burst memory read transactions
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:00:11.0, mfunc 0x0fc01d02, devctl 0x66
drivers/pcmcia/ti113x.h pci_irq_status = 0
Yenta TI: socket 0000:00:11.0 probing PCI interrupt failed, trying to fix
Yenta TI: socket 0000:00:11.0 falling back to parallel PCI interrupts
Yenta TI: socket 0000:00:11.0 no PCI interrupts. Fish. Please report.
CPU 0 Unable to handle kernel paging request at virtual address 00000004, epc =0
....
As far I understand driver cant get irq for this card but when I disable
this driver I can see(via cat /proc/pci) that cardbus have irq 4... :(
Ideas\advices are wellcome!
--
Dmitriy Tochansky
toch@dfpost.ru
JID: dtoch@jabber.ru
|