I found what cause my problem after adding
select SYS_SUPPORTS_BIG_ENDIAN
select SYS_SUPPORTS_32BIT_KERNEL
in Kconfig compilation start.
Sorry for posting stupid questions..
Best regards Mile
-----Original Message-----
From: linux-mips-bounce@linux-mips.org
[mailto:linux-mips-bounce@linux-mips.org] On Behalf Of Mile Davidovic
Sent: Thursday, April 07, 2005 5:24 PM
To: 'Geert Uytterhoeven'
Cc: 'Linux/MIPS Development'
Subject: RE: Porting new board
Thank for Your comment. Yes this was obviouse error but unfortunately it
does not work.
Best regards mile
-----Original Message-----
From: linux-mips-bounce@linux-mips.org
[mailto:linux-mips-bounce@linux-mips.org] On Behalf Of Geert Uytterhoeven
Sent: Thursday, April 07, 2005 4:05 PM
To: Mile Davidovic
Cc: Linux/MIPS Development
Subject: Re: Porting new board
On Thu, 7 Apr 2005, Mile Davidovic wrote:
> I try to port new board (MIPS 4KEC processor) to latest version of
> linux-mips kernel. I have question regarding Kconfig and adding new
> board.
> In arch/mips/Kconfig I add next lines:
>
> config MIPS_VGCA_EVA
> bool "Support for VGCA-Eva board"
> select SYS_SUPPORTS_BIG_ENDIAN
> help
> This enables support for the VGCA-EVA board.
>
> and in arch/mips/Makefile I add next lines:
> core-$(MIPS_VGCA_EVA) += arch/mips/vgca-eva/
^^^^^^^^^^^^^
> cflags-$(MIPS_VGCA_EVA) += -Iinclude/asm-mips/vgca-eva
^^^^^^^^^^^^^
> load-$(MIPS_VGCA_EVA) += 0xffffffff80100000
^^^^^^^^^^^^^
All of these should be `CONFIG_MIPS_VGCA_EVA' instead of `MIPS_VGCA_EVA'.
> But when I try to build kernel with:
> make menuconfig ---> choose VGCA-Eva board
> make arch=mips V=1 CROSS_COMPILE=mips-linux-
>
> it stop forever. When I try to choose some other board it work nice.
> Any comment?
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 --
geert@linux-m68k.org
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like
that.
-- Linus
Torvalds
|