RE: questions about making a script file for YAMON command

["Berg, Christian" <chrisb@mips.com>]

Hi Manling,

 

there is a variable called START in the YAMON environment. The contents of which is executed at YAMON start-up. So if you can fit your 'edit' commands in the space provided you're good to go. See page 22 of the YAMON user manual (http://www.mips.com/content/Documentation/MIPSDocumentation/Software/doclibrary). But this is getting off topic now...

 

Chris

-----Original Message-----
From: Ren, Manling [mailto:Manling.Ren@gbr.xerox.com]
Sent: Thursday, February 12, 2004 2:45 PM
To: linux-mips@linux-mips.org
Subject: RE: questions about making a script file for YAMON command

 

Dear the technical support team,

 

I am running YAMON on pb1100 board in Linux.  At the YAMON prompt, I need to change some registers by using the command "edit -32 0x########"  several times.  I wonder if I can put all these "edit" commands into a script file then run this file without typing any more commands?  How can I achieve this if it is possible.  It seems that the "load" command in YAMON is only supported srec file.  Could you give me some clues please.  Thanks a lot.

 

Regards,

Manling

 

____________________________
Manling Ren  J                              

Welwyn OPDU Software Architecture Team
OPDU                   
Xerox Limited Technical Centre
DP2        
Bessemer Road              
Welwyn Garden City  AL7 1HE        
Hertfordshire              
UK                         
%    +44 (0)1707 35 2704                 
(     8 668 2704 (xerox intranet)        
4     +44 (0)1707 35 3947        
*    Manling.Ren@gbr.xerox.com 
_________________________________