Dear the technical support team,
I am running YAMON on pb1100 board in
Linux. At the YAMON prompt, I need to change some registers by
using the command "edit -32 0x########" several times. I wonder if
I can put all these "edit" commands into a script file then run this file
without typing any more commands? How can I achieve this if it is
possible. It seems that the "load" command in YAMON is only supported
srec file. Could you give me some clues please. Thanks a
lot.
Regards,
Manling
____________________________
Manling Ren J
Welwyn OPDU Software Architecture Team
OPDU
Xerox Limited Technical
Centre
DP2
Bessemer Road
Welwyn Garden City AL7
1HE
Hertfordshire
UK
% +44 (0)1707 35 2704
( 8 668 2704 (xerox
intranet)
4 +44 (0)1707 35
3947
*
Manling.Ren@gbr.xerox.com
_________________________________