configuring 2 ethernet ports

[David Kesselring <dkesselr@mmc.atmel.com>]

I am trying to setup a pci wlan nic on a Malta board. I've compiled the
driver into the kernel and I have setup
/etc/sysconfig/network-scripts/ifcfg-eth1. After boot, when I look at
/proc/pci it looks like the system detected the card fine but ifconfig
only shows eth0 (the builtin port). How is the pci id linked to a
particular driver? What else do I need to do? I've scoured google but have
not come up with an answer. Thanks again,

David Kesselring
Atmel MMC
dkesselr@mmc.atmel.com
919-462-6587