| To: | Ralf Baechle <ralf@linux-mips.org> |
|---|---|
| Subject: | Re: [patch] cp0.config access macros |
| From: | "Maciej W. Rozycki" <macro@ds2.pg.gda.pl> |
| Date: | Tue, 15 Apr 2003 18:45:51 +0200 (MET DST) |
| Cc: | linux-mips@linux-mips.org |
| In-reply-to: | <20030415163558.B8778@linux-mips.org> |
| Organization: | Technical University of Gdansk |
| Original-recipient: | rfc822;linux-mips@linux-mips.org |
| Sender: | linux-mips-bounce@linux-mips.org |
On Tue, 15 Apr 2003, Ralf Baechle wrote: > (I'm not sure if in case of the IC, IB, DC and DB bits this is not adding > some confusion - the same bits with slightly different meaning or position > exist in various processors so we may want some distinguishable names > eventually) I've put specific macros for such bits in the R10k section. These shared among a few processors (and not necessarily only the ones you mention) could get different names to emphasize they are not really generic, but I have no obvious candidate for an adequate prefix. Any proposals? -- + Maciej W. Rozycki, Technical University of Gdansk, Poland + +--------------------------------------------------------------+ + e-mail: macro@ds2.pg.gda.pl, PGP key available + |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: wbflush() abuse for TOSHIBA_RBTX4927, Maciej W. Rozycki |
|---|---|
| Next by Date: | Re: rtc_[gs]et_time(), Jun Sun |
| Previous by Thread: | Re: [patch] cp0.config access macros, Ralf Baechle |
| Next by Thread: | [patch] do_IRQ() and init_i8259_irqs() declarations, Maciej W. Rozycki |
| Indexes: | [Date] [Thread] [Top] [All Lists] |