linux-mips
[Top] [All Lists]

Re: [patch] VR4181A and SMVR4181A

To: linux-mips@linux-mips.org
Subject: Re: [patch] VR4181A and SMVR4181A
From: Kunihiko IMAI <bak@d2.dion.ne.jp>
Date: Sun, 16 Feb 2003 00:22:56 +0900
In-reply-to: <200302151117.16972.jscheel@activevb.de>
Original-recipient: rfc822;linux-mips@linux-mips.org
References: <20030213155833.56019323.yoichi_yuasa@montavista.co.jp> <200302151117.16972.jscheel@activevb.de>
Sender: linux-mips-bounce@linux-mips.org
Hi,

On Sat, 15 Feb 2003 11:17:16 +0100
Julian Scheel <jscheel@activevb.de> wrote:

> jscheel/Programmieren/cmms/linux/include/asm/gcc -G 0 -mno-abicalls -fno-pic 
> -pipe -mcpu=r4600 -mips2 -Wa,--trap   -nostdinc -iwithprefix include 
> -DKBUILD_BASENAME=pmu  -c -o pmu.o pmu.c
> {standard input}: Assembler messages:
> {standard input}:125: Warning: Tried to set unrecognized symbol: vr4100
> 
> {standard input}:126: Error: opcode not supported on this processor `standby'
> make[1]: *** [pmu.o] Error 1
> make[1]: Leaving directory 
> `/home/jscheel/Programmieren/cmms/linux/arch/mips/vr4181a/common'
> make: *** [_dir_arch/mips/vr4181a/common] Error 2

I met this error, too.  This means that your assembler didn't
recognize the instruction 'standby'.

To escape this error, quick and dirty method, replace 'standby' with 'cop0
0x21'.  These means same instruction.

Thanks.
_._. __._  _ . ... _  .___ ._. _____ _... ._ _._ _.._. .____  _ . ... _

                                                          Kunihiko IMAI

<Prev in Thread] Current Thread [Next in Thread>