| To: | Skippie <skippie@skynet.be> |
|---|---|
| Subject: | Re: XFree XZ support |
| From: | Ralf Baechle <ralf@linux-mips.org> |
| Date: | Wed, 29 Jan 2003 14:50:06 +0100 |
| Cc: | linux-mips@linux-mips.org |
| In-reply-to: | <20030129131542.D9C3C13EC0A@crassus.kulnet.kuleuven.ac.be>; from skippie@skynet.be on Wed, Jan 29, 2003 at 02:15:41PM +0100 |
| Original-recipient: | rfc822;linux-mips@linux-mips.org |
| References: | <20030129131542.D9C3C13EC0A@crassus.kulnet.kuleuven.ac.be> |
| Sender: | linux-mips-bounce@linux-mips.org |
| User-agent: | Mutt/1.2.5.1i |
On Wed, Jan 29, 2003 at 02:15:41PM +0100, Skippie wrote: > could it than be possible to use fbdev for the xz card, or is this also > unsupported? This is a card that's magnitudes too complex to support. Even with docs it was to hard. Something as trivial as printing a character to the screen involves writing firmware for the i860 processor(s) of the XZ. Ralf |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: XFree XZ support, Skippie |
|---|---|
| Next by Date: | Re: unaligned load in branch delay slot, Ralf Baechle |
| Previous by Thread: | Re: XFree XZ support, Skippie |
| Next by Thread: | Re: XFree XZ support, Skippie |
| Indexes: | [Date] [Thread] [Top] [All Lists] |