linux-mips
[Top] [All Lists]

Re: sys_execve problem

To: <sseeger@stellartec.com>
Subject: Re: sys_execve problem
From: "Bradley D. LaRonde" <brad@ltc.com>
Date: Fri, 5 Jul 2002 19:39:24 -0400
Cc: <linux-mips@oss.sgi.com>
References: <01c501c2243f$2951c700$3501a8c0@wssseeger>
Sender: owner-linux-mips@oss.sgi.com
Is your init static?  Does it need ld.so?  Is ld.so executable (that's a
tricky one).

Regards,
Brad

----- Original Message -----
From: "Steven Seeger" <sseeger@stellartec.com>
To: <linux-mips@oss.sgi.com>
Sent: Friday, July 05, 2002 12:15 PM
Subject: sys_execve problem


> Hey guys. I have compiled 2.4.19-ac1 from the CVS with the linux_2_4 tag
for
> my NEC Osprey board (NEC VR4181) It boots fine and stuff, but doesn't load
> init. I've confirmed with simple print statements that do_execve is
> returning a 0 at the point in fs/exec.c where it says "/* execve success
*/"
> and yet init doesn't load. The system just sits there. I see on a scope
that
> my timer interrupt is firing every 10 ms and the serial console responds
> properly. It echos characters and stops the echo when it receives a ctrl-S
> and resumes it on ctrl-Q. Obviously this is the last little part of the
> kernel to work though here. Any ideas?
>
> Steve


<Prev in Thread] Current Thread [Next in Thread>