Also, does this have to be done only for PCI I/O, or PCI memory also?
Matthew D. Dharm Senior Software Designer
Momentum Computer Inc. 1815 Aston Ave. Suite 107
(760) 431-8663 X-115 Carlsbad, CA 92008-7310
Momentum Works For You www.momenco.com
> -----Original Message-----
> From: Ralf Baechle [mailto:firstname.lastname@example.org]
> Sent: Wednesday, February 20, 2002 5:58 PM
> To: Matthew Dharm
> Cc: Linux-MIPS
> Subject: Re: set_io_port_base()?
> On Wed, Feb 20, 2002 at 05:36:05PM -0800, Matthew Dharm wrote:
> > Now, I'm pretty sure this has something to do with the initcall to
> > set_io_port_base() and ioremap(), which are in my setup.c
> (copied from
> > linux/arch/mips/gt64120/momenco_ocelot/setup.c and
> modified). Without
> > that bit of code at the bottom of that function, I don't even get
> > this -- it just crashes. So I know I need this code, but
> I'm just not
> > certain what/how I should be using it...
> > My initial guess is that it's used to map some virtual
> address space
> > onto the physical addresses needed to actually generate PCI I/O
> > transactions, but that's just a guess. If that's right,
> then the code
> > I'm using _should_ work... I call ioremap() with the
> physical base and
> > size, and then set_io_port_base() using the result of ioremap().
> That is exactly the intended use.