I considered that, but since only this small chuck of run-once surrogate
bios autoconfig code needs to know, I figured better keep it separate.
----- Original Message -----
From: "Jun Sun" <email@example.com>
To: "Bradley D. LaRonde" <firstname.lastname@example.org>
Cc: <email@example.com>; <firstname.lastname@example.org>
Sent: Monday, October 29, 2001 2:24 PM
Subject: Re: PATCH: pci_auto bridge support
> Have you considered embedding "topbus" argument into hose structure? That
> sounds like potentially better solution.
> "Bradley D. LaRonde" wrote:
> > 2001-10-26 Bradley D. LaRonde <email@example.com>
> > * PCI bridge support. See change log entry below.
> > --- arch/mips/kernel/pci_auto.c 2001/08/18 06:21:53 1.1
> > +++ arch/mips/kernel/pci_auto.c 2001/10/27 01:01:21
> > @@ -4,6 +4,7 @@
> > * Author: Matt Porter <firstname.lastname@example.org>
> > *
> > * Copyright 2000, 2001 MontaVista Software Inc.
> > + * Copyright 2001 Bradley D. LaRonde <email@example.com>
> > *
> > * This program is free software; you can redistribute it and/or
> > * under the terms of the GNU General Public License as published by
> > @@ -19,6 +20,15 @@
> > * . change most int to u32.
> > *
> > * Further modified to include it as mips generic code,
> > + *
> > + * 2001-10-26 Bradley D. LaRonde <firstname.lastname@example.org>
> > + * - Add a top_bus argument to the "early config" functions so that
> > + * they can set a fake parent bus pointer to convince the underlying
> > + * pci ops to use type 1 configuration for sub busses.
> > + * - Set bridge base and limit registers correctly.
> > + * - Align io and memory base properly before and after bridge setup.
> > + * - Don't fall through to pci_setup_bars for bridge.
> > + * - Reformat the debug output to look more like lspci's output.
> > */