Re: I am interested in helping port to Indigo

["Fernando D. Mato Mira" <matomira@acm.org>]

At 02:30 PM 10/12/98 -0700, darkaeon wrote:

>  Perhaps you can supply us with a hinv output and picture of it, as
I
>have never heard of an Indigo with a R4400...

1 150 MHZ IP20 Processor
FPU: MIPS R4000 Floating Point Coprocessor Revision: 0.0
CPU: MIPS R4400 Processor Chip Revision: 5.0
On-board serial ports: 2
On-board bi-directional parallel port
Data cache size: 16 Kbytes
Instruction cache size: 16 Kbytes
Secondary unified instruction/data cache size: 1 Mbyte on Processor
0
Main memory size: 256 Mbytes
Integral Ethernet: ec0, version 1
Integral SCSI controller 0: Version WD33C93B, revision C
  Tape drive: unit 7 on SCSI controller 0: DAT
  Tape drive: unit 6 on SCSI controller 0: QIC 150
  CDROM: unit 5 on SCSI controller 0
  Disk drive: unit 4 on SCSI controller 0
  Disk drive: unit 3 on SCSI controller 0
    Disk drive / removable media: unit 2 on SCSI
controller 0: 720K/1.44M floppy
  Disk drive: unit 1 on SCSI controller 0
Iris Audio Processor: revision 10
Graphics board: GR2-Elan


There're a couple of old pictures att
www.vrai.com, but how
could you tell? :-)

BTW, 6.2 disk is #3. Used to nvram OSLoadPartition to #1, slide 5.3
in
and compile for MIPS ABI 1.0 . I should still get a big disk for 6.5 dual
boot..






Fernando D. Mato
Mira                    
Real-Time SW Eng & Networking            
Advanced Systems Engineering Division
CSEM - Centre Suisse d'Electronique et de
Microtechnique                                 
Jaquet-Droz 1                         email:  matomira@acm.org
CH-2007 Neuchatel                       tel: +41 (32) 720-5157
Switzerland                             FAX: +41 (32) 720-5720

www.csem.ch                  www.vrai.com              
http://ligwww.epfl.ch/matomira.html