linux-mips
[Top] [All Lists]

RE: Making Progress

To: linux@cthulhu.engr.sgi.com
Subject: RE: Making Progress
From: Michael Hill <mdhill@interlog.com>
Date: Fri, 8 May 1998 05:48:26 -0400 (EDT)
In-reply-to: <Pine.LNX.3.95.980507131537.20653F-100000@lager.engsoc.carleton.ca>
References: <60222E63C9F4D011915F00A02435011C126253@BART> <Pine.LNX.3.95.980507131537.20653F-100000@lager.engsoc.carleton.ca>
Reply-to: mdhill@interlog.com
Sender: owner-linux@cthulhu.engr.sgi.com
Alex deVries writes:
 > 
 > Hmmm.  Odd.  Can you give us the results of a 'hinv'?
 > 
Iris Audio Processor: version A2 revision 4.1.0
1 133 MHZ IP22 Processor
FPU: MIPS R4600 Floating Point Coprocessor Revision: 2.0
CPU: MIPS R4600 Processor Chip Revision: 2.0
On-board serial ports: 2
On-board bi-directional parallel port
Data cache size: 16 Kbytes
Instruction cache size: 16 Kbytes
Main memory size: 32 Mbytes
Vino video: unit 0, revision 0
Integral ISDN: Basic Rate Interface unit 0, revision 1.0
Integral Ethernet: ec0, version 1
Integral SCSI controller 0: Version WD33C93B, revision D
  Disk drive: unit 4 on SCSI controller 0
  Disk drive: unit 1 on SCSI controller 0
Graphics board: Indy 8-bit

Here's this morning's result from 'boot /vmlinux root=/dev/sdb
ip=none':

[snip]
scsi : detected 2 SCSI disks total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 1070496 [522 MB]
[0.5 GB]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 2400302 [1172 MB]
[1.2 GB]
sgiseeq.c: David S. Miller (dm@engr.sgi.com)
eth0: SGI Seeq8003 08:00:69:07:e3:0d
Sending BOOTP and RARP requests............. timed out!
IP-Config: Auto-configuration of network failed.
Partition check:
[end]

Next I'll try adding a partition to be checked.

Mike
-- 
Michael Hill
Toronto, Canada
mdhill@interlog.com


<Prev in Thread] Current Thread [Next in Thread>