The fact that is has two network interfaces is probably the problem I
would think, the PMAD-AA is not supported in the standard kernel, and
requires my version of the dec_esp driver, however the first interface
would then probably crash :-), there is still some work to try merge the
two drivers ...
Dave.
On Thu, 3 Jun 1999, Houten K.H.C. van (Karel) wrote:
>
> Hi all,
>
> Hagen has problems with his 260. It seems to panic during bootp.
> Has anyone seen this before? Or even has a hint for a solution?
>
> Regards,
> Karel.
>
> ------- Forwarded Message
>
> Hi,
>
> following your instructions how to boot a DECstation 5000/260 with your
> LINUX-Kernel"vmlinux-decR4k.ecoff" i got following error message:
>
> *********************************************************************************
> **********************
> KN05 V2.1k (PC: 0x80064684, SP: 0x87ffbcd8)
> 3/prcache 3/prcache(14) * * *
> ?RST
>
> - -tftp boot(3), bootp .. 193.17.138.81:/tftpboot/vmlinux-decR4k.ecoff
> - -tftp load 1239984 +0 +124128
> This DECstation is a DS5000/2x0
> Loading R4000 MMU routines.
> CPU revision is: 00000440
> Primary instruction cache 16kb, linesize 16 bytes)
> Primary data cache 16kb, linesize 16 bytes)
> Secondary cache sized at 1024K linesize 32
> Linux version 2.2.1 (root@elrond) (gcc version egcs-2.90.27 980315 (egcs-1.0.2
> release)) #2 Sun May 23 11:29:22 MEST 1999
> Calibrating delay loop... 59.90 BogoMIPS
> Memory: 128160k/131068k available (1080k kernel code, 1540k data)
> Checking for 'wait' instruction... unavailable.
> POSIX conformance testing by UNIFIX
> TURBOchannel rev. 1 at 25.0 MHz (no parity)
> slot 0: DEC PMAD-AA V5.3a
> slot 1: DEC PMAZ-AA V5.3d
> slot 2: DEC PMAZ-AA V5.3d
> Linux NET4.0 for Linux 2.2
> Based upon Swansea University Computer Society NET3.039
> NET4: Unix domain sockets 1.0 for Linux NET4.0.
> NET4: Linux TCP/IP 1.0 for NET4.0
> IP Protocols: ICMP, UDP, TCP
> Starting kswapd v 1.5
> DECstation Z8530 serial driver version 0.03
> tty00 at 0xbf900001 (irq = 4) is a Z85C30 SCC
> tty01 at 0xbf900009 (irq = 4) is a Z85C30 SCC
> tty02 at 0xbf980001 (irq = 4) is a Z85C30 SCC
> tty03 at 0xbf980009 (irq = 4) is a Z85C30 SCC
> loop: registered device at major 7
> SCSI ID 7 Clock 25 MHz CCF=0 Time-Out 167 NCR53C9x(esp236) detected
> ESP: Total of 1 ESP hosts found, 1 actually in use.
> scsi0 : ESP236
> scsi : 1 host.
> Vendor: DEC Model: RZ26 (C) DEC Rev: 392A
> Type: Direct-Access ANSI SCSI revision: 02
> Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
> Vendor: DEC Model: RZ26 (C) DEC Rev: 392A
> Type: Direct-Access ANSI SCSI revision: 02
> Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0
> Vendor: DEC Model: RRD42 (C) DEC Rev: 4.5d
> Type: CD-ROM ANSI SCSI revision: 02
> Detected scsi CD-ROM sr0 at scsi0, channel 0, id 4, lun 0
> Vendor: DEC Model: TLZ06 (C)DEC Rev: 0491
> Type: Sequential-Access ANSI SCSI revision: 02
> scsi : detected 1 SCSI cdrom 2 SCSI disks total.
> sr0: scsi3-mmc drive: 0x/0x caddy
> Uniform CDROM driver Revision: 2.52
> esp0: target 0 [period 200ns offset 15 5.00MHz synchronous SCSI]
> SCSI device sda: hdwr sector= 512 bytes. Sectors= 2050860 [1001 MB] [1.0 GB]
> esp0: target 1 [period 200ns offset 15 5.00MHz synchronous SCSI]
> SCSI device sdb: hdwr sector= 512 bytes. Sectors= 2050860 [1001 MB] [1.0 GB]
> declance.c: v0.008 by Linux Mips DECstation task force
> eth0: IOASIC onboard LANCE, addr = 08:00:2b:39:bb:25, irq = 3
> eth1: PMAD-AA, addr = 08:00:2b:3c:95:7f, irq = 5
> Sending BOOTP requests...<1>Unable to handle kernel paging request at virtual
> address 00000000, epc == 8010837c, ra == 801090b8
> Oops: 0001
> $0 : 00000000 10010c00 0000ffff 00000017
> $4 : 00000000 802d4e04 00000196 00000017
> $8 : 0000ffff 8012c9e8 00000006 80173ca8
> $12: 00000001 00000001 80160000 802d4e02
> $16: be000000 802de000 8016d110 802d5040
> $20: 00000000 10010c01 be100000 80140000
> $24: 00000001 10010c01
> $28: 87ffa000 87ffbe28 80140000 801090b8
> epc : 8010837c
> Status: 10010c02
> Cause : 1000000c
> Process swapper (pid: 1, stackpage=87ffa000)
> Stack: 10010c01 00000015 80130000 00000f00 802d5040 87fe84a0 8016d110 8016d178
> 00000000 00000f00 80160000 800c9bf8 802d5040 00000015 000001b0 80170000
> 87fe84a0 802d5040 80180000 800c5154 802d4e10 802d5040 8016d110 8016d178
> 802d4e10 802d5040 8016d110 801545e4 00000000 8013b8d9 87ffbd48 00001003
> 8016d178 00000188 87fea520 00000000 80160000 00000001 00000e31 80154650
> 80140000 ...
> Call Trace: [<80130000>] [<800c9bf8>] [<800c5154>] [<8013b8d9>] [<80140000>]
> [<801041e8>] [<8013b8bc>] [<8013b8dc>] [<8013b8e4>] [<8013b8e4>] [<80140000>]
> [<8004816c>] [<80140000>] [<80049eec>] [<8004816c>] [<8004816c>] [<80048180>]
> [<80049efc>] [<80140000>] [<80049eec>]
> Code: 24e3ffff 00603821 3063ffff <a4820000> 24840002 94a20000 24a50002
> a4820000 24840002
> Aiee, killing interrupt handler
> *********************************************************************************
> **********************
>
> Could you help me ?
>
> Regards
>
> Hagen Schubert
>
>
>
>
> ------- End of Forwarded Message
>
>
> --
> Karel van Houten
>
> ----------------------------------------------------------
> The box said "Requires Windows 95 or better."
> I can't understand why it won't work on my Linux computer.
> ----------------------------------------------------------
>
>
------------ David Airlie, David.Airlie@ul.ie,airlied@skynet --------
Telecommunications Research Centre, ECE Dept, University of Limerick \
http://www.csn.ul.ie/~airlied -- Telecommunications Researcher \
--- TEL: +353-61-202695 -----------------------------------------------
|